Yup, see the 2nd video in the gallery. And don't forget to connect the NFT connector of the container to the winch on the truck, as shown in the video. Then, the front passanger can control the SAM container. Controls aren't intuitive, but try them out a little, to get a feel for it.

can it control and carry your SAM container?

Sure, set it's gear ratio in the editor higher. But keep in mind, that there are two sliders moving the frame.
If the gear ratio is changed, I don't know, if the frame can still lug heavy containers.

is there anyway to make the slider that grabs the container any faster ??

Keep in mind W increases throttle and S decreases it/applies brakes. If you want to reverse, shift gear down until gear indicator shows 0. Reverse light comes on and an aural warning tone is audible.

If you try to reverse you just keep accelerating

i just learned something new because of that video. thanks

Thank you.

Like this:
https://youtu.be/DXGBMaHjip4

im confused can you like make a tutorial video.

Open the truck, then select the SELECTION GRID tool and open the SAM container there. Then paste it, so that you don't overwrite any blocks.

You may connect the cable connector at the front of the container to the winch at the back of the trucks cab (in the editor), so the container wont slide of. Then activate the three connector control in the truck, so the container is connected to the truck. The cable connection also allows to control the container from the right seat.

But you should be able to use any other means of container transport for the sam container, because it's standard sized.

how to i put on the sam container you made aswell on it. inside the ditor.