安装 Steam
登录
|
语言
繁體中文(繁体中文)
日本語(日语)
한국어(韩语)
ไทย(泰语)
български(保加利亚语)
Čeština(捷克语)
Dansk(丹麦语)
Deutsch(德语)
English(英语)
Español-España(西班牙语 - 西班牙)
Español - Latinoamérica(西班牙语 - 拉丁美洲)
Ελληνικά(希腊语)
Français(法语)
Italiano(意大利语)
Bahasa Indonesia(印度尼西亚语)
Magyar(匈牙利语)
Nederlands(荷兰语)
Norsk(挪威语)
Polski(波兰语)
Português(葡萄牙语 - 葡萄牙)
Português-Brasil(葡萄牙语 - 巴西)
Română(罗马尼亚语)
Русский(俄语)
Suomi(芬兰语)
Svenska(瑞典语)
Türkçe(土耳其语)
Tiếng Việt(越南语)
Українська(乌克兰语)
报告翻译问题






You can edit if you want to.
How is your physics detail setting?
I found it gets stuck in low physics.
I will fix it and update in a few days but you can fix it by yourself.
2. Flip "master arm" switch.
3. Push the trigger key.
4. Probe deploys.
5. Push trigger again to retract the probe.
I don't understand. Where is the dash on my creation?
Could you read the description, please?
I wrote it at the 'FCS.'
1. Turn on the "power" switch on the left panel.
2. Turn on the "idle" switch on the right panel.
3. Hold the "compressor" button on the left panel until the engine starts.
4. Turn off the "idle" switch and you can control throttle.
If the value is 3, it's VTOL. But if other, it's not VTOL.
Or the engine sometimes stack due to poor physics.
Flight assist is almost like a gyro.