Hi!, What is the name of this microcontroller in stormworks, have downloaded it but i cant find it...

@ktgs9437 Thanks for the reply. I have tried that, unfortunately the ap sends an off signal at each way point. Then it turns back on for the next. I have been working on trying to use a timer to gap the On-off-on sequence. On the screens it shows the total number of way points "Q:" It also shows the total m,km left to the end of the way point sequence. That was why I asked about where to find this info that is output onto the screen. That would allow me to either put an off command when the way point number is <1 or the total meters, km is <1. I'll keep trying. Thanks

>Captain
In the composite output of the map viewer microcontroller, there is a channel (APonSignal) that outputs a signal only when the autopilot is on.
Maybe you can use this to easily create the function you want.

I'm trying to create an auto stop function for the auto pilot using your screens. I would like to add a condition where when the Q: # = 0 it will trigger the stop function. I'm curious if you know where the Q: (number of way points) is located in the code so that I may link to it. Thanks.

Great! Thank you!

>ScraM177-RGL
When there is no terrain or objects in the line of sight of the stabilized camera due to reasons such as looking at the sky, it seems that the coordinate output of the camera goes wrong, resulting in erratic behavior.
Currently, I think the only solution is to operate with caution to prevent the problem from occurring. I apologize for the inconvenience.

>Daendepaen
There are no A/D and W/S outputs.
Map viewer microcontroller outputs coordinate and other data necessary for autopilot operation, so please use it in combination with other autopilot microcontrollers.

This is the best MFD on the workshop dude, congratz! From which composite output, and which channel do I take the a/d and w/s output for the AP?

Yep. I found it!! Thanks again.
Sometimes my stabilized cam gets crazy rotating when I want to slave it to a point, or when I reset it. Anything I can do to solve it?

>ScraM177-RGL
Thanks!
Autopilot data output exists as a composite output to the map viewer microcontroller.

This is amazing. But I can't find where is the autopilot output to control the ship

Damn dude. I'd say this is by far the best setup I have ever seen in Stormworks.

Really nice! Thanks!