thanks!

After placing the rotors like that I remove the rotorheads and build the crane arm, including the heads. After that you have to manually put the crane arm in a position where the rotors and heads can be connected via the control menu (with a lifting ship) and voila. You can do that with any amount of rotors, just prebuild the arm with the heads and connect it manually. Don´t forget to set the rotor´s offset values to 0 on small grids and -40 on large grids, so they don´t push or pull against each other. About the collision, that´s just trial and error, if it´s jittering after placing try again. Hope I could help you :)

There are a few things i need to know: how did you place two rotors to move the same grid (crane double rotor elevation) and how did you not make the rotors colide with the blocks near them? i'm always having problems with this

Thanks! Yeah, me too :)

this is great! i wish it had more popularity tho

Thanks!

So pretty. I like

Thx!

very cool