- Flags Update (Part of Sail Update)

Updated Colsac III.

Updated Colsac III.

Added
- Remainder of bilge system
- Water level gauges for pontoons
- Security Camera to engineering

Changed
-Massive overhaul to hull of the vessel. Middle section has been raised up to the car deck. Pontoons are now separate from one another. Access hatch in engineering has been removed and replaced with two new hatches on the car deck that access each of the pontoons.

Overall shape of the pontoons has also changed with a reduction in size too, fuel tanks shifted forward for better center of mass. Tweaks to pretty much every other system and pipe in the hull too.

-New Doors (again), the actual vessels doors were a different color and have a window in each of them. As such they have been replaced with custom doors and once again require a button to open them.
-Guideline winches were depreciated and have been replaced with modern winches. Location of center guidelines altered slightly to more accurately replicate the actual vessel.

This is a pretty big overhaul to the ship including stuff I have been putting off for years, I will try to include all changes but its 5 AM and a lot of stuff, I will probably miss some things.

Added
-Bilge Pump, controls can be found in engine room. (another is planned)
-Several lights which are for decorative purposes, they are too bright and have been left intentionally unplugged. Bring sunglasses if you plug them back in.
-Cables have been attached to the loading ramps, these are also decorative but are how ramps are controlled on actual Colsac III
-Several decorative assets in multiple locations
-Added ability to switch between cameras on big monitor in wheel house. Final camera location is pending. Using Anohito microcontroller

Changed
-Massive overhaul to wheel house and catwalk. Both reduced in size to bring them more in line with actual vessel.
Interior of Wheel house rearranged to allow for second door and decreased size of the wheel house.
-Replaced flooring with railing pieces in several locations to emulate grating.


Removed
-Large chunks of wheel house and cat walks as mentioned above.

As mentioned above I am planning to add another bilge pump, security camera (not sure if I want it on the deck or in the engine room), overhaul bottom shape of vessel to be more in line with actual design.

Updated Colsac III.

Added
-Larger rear camera monitor in wheel house for easier viewing from wheel when in reverse
-Several seats added to engine room and wheel house
-weighted blocks to bring bow down closer to stern depth
-Flashlight added to wheel house

Changed
-New engine cooling system has been place below deck, as the old one was no longer functioning properly.
(this had the added benefit of fixing a drift to one side too somehow, steering also easier as a result)
-Lowered engine RPS
-Minor changes to transmitter
-Replaced one of the first aid kits on the deck with a flair gun
-Electric doors and hatches replaced with manual counterparts
-Stair railings updated to use inclined railing parts
-Several toggle buttons changed to breakers for light switches. Made engine room lights separate from wheel house

Changed
-Cooling System has been tweaked to prevent overheating. Engine still runs a bit hot during idling, but should still be ok.

Known Bugs:
-Vehicle veering to the right again, cause unknown.

Updated Colsac III .

Updated Colsac III .

Added:
Anchors to ferry near life boat from quicker removal of cables during emergency

Changed:

Frame of Life Boat
Engine of Life Boat to modular engine based off Mr. N Jersey design
Frame alterations

Known Bugs:

Cooling seems to have broken since I last played, suggest running throttle at around 60 with full clutch to avoid overheating for the time being.

Updated Colsac III .

Changed
-Decreased Fuel tank size
-Removed several weight blocks

Ship was listing slightly and pulling to the right, this should be fixed.