Stormworks: Build and Rescue

Stormworks: Build and Rescue

Colsac III
正在显示第 11 - 15 项,共 15 项条目
< 1  >
更新于:2020 年 10 月 12 日 下午 8:56

New
-Added Additional diesel engine, speed minimally improved. (Will continue to try and improve speed)
-Headset added to helm position
-Additional heater in engine room (heater activation also in engine room now)

Changed
-Wheel house interior and windows completely redone
-Traffic lights for ramps now operate off a single switch for each light
-Decorative red box on exterior side now contains 3 medkits
-Life boat hull altered, fuel gauge added to top of prop, several pieces of equipment added as well.
-Life boat winches changed to use rope and anchors (was previously mag alls, recommend raising slightly before embarking)
-Tires replaced with blocks to try and better emulate life preserver

Removed
-Several displays from wheel house that were irrelevant to this vehicles needs and functions. (coordinates, humidity, etc.)

To do
-Overhaul engine room display gauges for more detailed information then what is provided to wheel house.

更新于:2020 年 9 月 24 日 下午 10:11

Updated Colsac III . Renamed vehicle from "Colsac III (Advanced)" to "Colsac III ".

A recent visit from OSHA has resulted in several modifications to the vessel!


Added:
-Railings and access gates to the staircases leading to the wheelhouse.
-Nav lights, they are activated by the same button that activates the deck lights in the wheel house.
-Additional fuel tank opposite initial tank has been installed
-Flags based off of the wonderful design used on the MSV Post (check it out)

Changed:
-Both the Colsac and her life boat have been changed from radiator cooling to water cooling. This did not result in a increase in speed. However the engines will not overheat at full throttle

-Fuel and electric refuel/charging access have been placed behind an access panel located in the same location on the port side. The fuel attach point was changed to a hose attachment, an additional electric cable attachment was added as well.

Known issues: Vessel pulling to port side during testing when close to land. Seems to correct when further out to sea. Cause unknown.

更新于:2020 年 9 月 19 日 下午 8:08

Updated Colsac III (Advanced).

-Replaced decorative red GPS sensors with functional fire extinguishers. Also added fire extinguisher in wheel house and to entrance of the engine bay.
-Readded life boat (now updated to advanced mode and other changes)
-Wheel House shortened and several buttons renamed

更新于:2019 年 10 月 20 日 上午 1:23

Updated Colsac III (Advanced).

Added:
-Heater, PA, and video Systems
-Additional heat sinks to avoid overheating (Engine still runs hot, but shouldn't explode.)

Changed:
-Several model changes have been made including the addition of new lighting, and repainting in some places for a more consistent appearance.
-Changes to gearbox resulting in slightly higher speed.

Removed:
-All Stop button was removed as it was not working as intended.

Known issues:
-As mentioned above engine still runs hot
-Wheelhouse and stairways are to large, no plans to fix at this time

更新于:2018 年 10 月 6 日 下午 5:03

Uploaded Colsac III (Advanced) to the Workshop.