Train Simulator Classic

Train Simulator Classic

130 个评价
Yard Work (San Bernardino) Part 2
   
奖励
收藏
已收藏
取消收藏
文件大小
发表于
85.496 KB
2017 年 1 月 15 日 上午 10:39
1 项改动说明 ( 查看 )
您需要 DLC 才能使用该物品。

订阅以下载
Yard Work (San Bernardino) Part 2

在 RBJets 的 1 个合集中
Cajon Pass Series
18 件物品
描述
(Scenario #9 in series) The "Leaving San Bernardino" consist is now on its way back to Barstow, in Part 2 in the San Bernardino Yard you will finish loading some Container cars and then start to break up the "Leaving Barstow" consist before ending your shift.

Loco: EMD SW1500 Switcher Burlington - Difficulty: Easy - Length: 35 Mins

Click on above "Cajon Pass Series" collection link for scenario list/order.
27 条留言
RBJets  [作者] 4 月 22 日 下午 12:05 
I run the game in window mode. Seems better.
robmerlo 4 月 21 日 下午 8:55 
here is one i missed before enjoyed the shunting not sure why but immediately after finishing game crashed out but thank you for your efforts now on to leaving san bermardino part 2
RBJets  [作者] 2 月 19 日 下午 2:07 
Those locos are touchy, I really don't know if I really needed to have 2 of them together.
vivant123 2 月 19 日 上午 1:43 
and another thing.. i dunno but i felt as if the shunters were a bit slow to accelerate. as if the brakes were on or the cargo was just too heavy for the two shunters... just a feeling. dont know if that was really the case..but no prob getting the scenario done..
vivant123 2 月 19 日 上午 1:42 
It was a nice scenario but got a bit confused with the second set of loading/unloading containers. but with a bit of trial and error realised which cars had to be loaded/unloaded. Back to some mainline action... :steamhappy:
RBJets  [作者] 2024 年 5 月 17 日 下午 12:01 
Thanks Rob and crlynch. :)
robmerlo 2024 年 5 月 16 日 下午 11:35 
A neat little shunting scenario well done
crlynch 2022 年 10 月 3 日 下午 3:25 
Nice yard work, great series to date thanks.
RBJets  [作者] 2017 年 2 月 16 日 下午 7:47 
Yea I have switched to the helper in certain scenarios and noticed that you can't ask to pass signal unless you in the main loco. Just save after each completed task so if something goes wrong you can just start there.
john 2017 年 2 月 16 日 下午 7:45 
I did a resume from a saved position at the unload/load containers situation.No problems, but after I had dropped the containers and attempted to pick up the container flats at siding 2. The engine would not couple, it was then I noticed the instruction said to couple to the back of the lead engine, but it was the front of the helper which was contacting the flats. I then moved forward , dropped the helper in siding3, went back to 2 and could now couple and finished the scenario. Looks like I missed an instruction to drop the helper of somewhere :-)