Stormworks: Build and Rescue

Stormworks: Build and Rescue

评价数不足
SGA.8 "Moose" | Long-Range Bushplane
   
奖励
收藏
已收藏
取消收藏
标签: v1.7.3
文件大小
发表于
更新日期
1.459 MB
2023 年 4 月 7 日 上午 11:47
2023 年 4 月 14 日 下午 5:20
2 项改动说明 ( 查看 )

订阅以下载
SGA.8 "Moose" | Long-Range Bushplane

在 MrMereScratch 的 2 个合集中
MrMere's Modern Stuff
29 件物品
The Best of MrMere
58 件物品
描述
Want to see more of what I make? Check out the Western War project!
-------------------------------------------------------------------------------------------------------
Enjoying the build? Make sure to leave a like and favorite!
As always, turn “Infinite Fuel” and “Infinite Electric” off!
-------------------------------------------------------------------------------------------------------
The Moose :
Backstory:
Introduced in the 50s, Sawyer General Aviation’s SGA.8 “Moose” reached the market as a low-cost and easily-maintained utility/passenger plane able to take paying customers anywhere they wanted thanks to its enormous range and STOL capabilities.

Although sporting only a small passenger capacity, it was widely used for charter flights and deliveries by most regional airlines up unto the 90s, with thousands of models produced.

--------------------

The “Moose” is roughly based off of the DHC-2 beaver with modeling reference taken from Sir Murtak’s Beaver, that just so happens to be one of the AI planes we see flying around the world of Stormworks.
-------------------------------------------------------------------------------------------------------
Specifications:
(*)Length: 12 Meters
(*)Width: 14.25 Meters
(*)Height: 3.75 Meters
(*)Weight: 1755 Mass Units
(*)Cost: $30,246
(*)Crew: 1-2
(*)Top Speed: ~140 Knots
(*)Fuel Tank: ~1938 Liters
(*)Full Throttle Range: 620 KM / ~150 Minutes
(*)Cruise Range: ~820 KM / ~260 Minutes
(*)Armament: N/A
(*)Propulsion: 8-Cylinder Radial powering a single three-bladed fixed-pitch prop
-------------------------------------------------------------------------------------------------------
Startup:
(1.) Below the pilot tray table and to the left is the power switch. Turn it on.
(2.) Turn on your “Engine Master” switch and the push starter.
(3.) Throttle up to .35 to taxi and turn on the “Release Wheel Brakes” switch.
(4.) Taxi onto the runway, and then set your throttle to full and turn on the “Lock Tailwheel Steering” switch.
-------------------------------------------------------------------------------------------------------
Extras:
Credits:
(*) Sawyer News
(*) ECU
(*) Fuel Computer
(*) Altitude Hold

Tags:
De Halivand, Beaver, DHC-2, Bush Plane, Regional Airliner, Cargo, MrMereScratch

Note: All workshop variations of this aircraft and the use of components are strictly banned NO MATTER WHAT
7 条留言
Frisher 2023 年 12 月 25 日 上午 9:34 
Is this by any chance inspired by the murphy moose and / or the beaver?
MrMereScratch  [作者] 2023 年 4 月 14 日 下午 5:20 
Fixed it!
MrMereScratch  [作者] 2023 年 4 月 14 日 下午 5:19 
OH. Agh, I keep forgetting to hook up the audio. I'll fix that right away!
NIJ 2023 年 4 月 14 日 下午 5:10 
it's not sending or receiving audio
MrMereScratch  [作者] 2023 年 4 月 9 日 下午 2:08 
@Nij, all systems work. Make sure you hold down the radio button and change to your proper channel
MrMereScratch  [作者] 2023 年 4 月 9 日 下午 2:04 
@Nij, they don't work? They should
NIJ 2023 年 4 月 9 日 下午 1:06 
I'm assuming that you are still working on this because it has radio controls but they don't work