订阅以下载
[LR1 ar] Orient Express - Steam Locomotive

[sws.flaffipony.rocks]

A diesel powered locomotive.

It is based on my BNSF Train.

Here is the train in another style called "Arcade and Attica": https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=1907062421

This train uses the Advanced Engine Mode!

• Auto throttle with slip control (select your target speed and the train will try to reach it)
  
• Special hull light effects
  
• Full walkthrough: Walk from front to the end of the train and even on connected waggons while driving
  
• Restroom with bed and outfits
  
• Arctic ready
  
• Compatible with my other waggons
  
• Remote control / Chaining: Chain as much of them as you want, in whatever direction you want and with any of my other waggons inbetween. Then control all from one pilot seat! (The only limit is your FPS)
  
• Maximum Speed: 240 kmh or 150 mph (used to be 400 km/h or 245mph before the update, needs 30 mins from donkk island to arctic)
  
• Fuel: 18000 liters (more then enough to go to the arctic at full speed)
  
• Hybrid Propulsion: Diesel Engine + Generator + Battery (Fully automatic)
  
• 4 Train wheel bases 1 Medium motor each (more traction and high speed)
  
• Emergency braking, Horn, far reaching light (Search light)
  
• Front and back lights (reacting to direction of movement)

1. Enter the control room
   
2. On the right side enable key button "Main ON"
   
3. On the left wall enable the button "Engines ON" to fire up the engine to produce energy
   
4. Release the brakes
   
5. Push the throttle
   
6. To drive backwards, hit the "reverse" button
   
7. Because the coal waggon is always connected the "control other vehicles" should be enabled at all times!

You can do way more than just drive with a single vehicle!


The battery status LED will light up yellow if you use too much energy (e.g when accelerating) or red when battery is lower then 20%.

The vehicle has 1 energy production system (engine + generator + battery).

There is one backup battery ( a medium one) which can be connected manually to the rest of the electrical network. It can be used to fire up the engine when your main battery is depleted and cannot fire up the engines by themselves. Once the battery is full again you should disconnect it again to be prepared for the next backup.

When chaining multiples of this vehicle (2, 3, 4 or more!):
We will call the vehicle you will control the complete chain "MASTER" from now on, all the others are called "SLAVES"
Spawn in a new vehicle and connect it one of both ends via the connectors
The direction of the vehicles do not matter
Do this for every SLAVE:

• Follow the easy startup procedure
  
• If the nose of this vehicle points into the opposite direction as the MASTER train, enable the "is reverse to master" button
  
• Enable "allow remote control". Once enabled the indicator near to it should light up green, if its yellow you have no connection to the MASTER train, check the connectors again.
  
• Disable the "reverse" button
  
• Disable the "emergency brake" (because this will override the remote brakes value)
  
• Apply brakes (so in case you decouple this train again it does not move away)
  
• Do this in the MASTER:
  
• Enable "control others"

Now you can release the brakes in the MASTER, push the throttle and here you go. Reverse will work like expected.

When chaining with other compatible waggons (see my collection):

• Enable "control others" button on the right hand side of the control room.
  This will allow you to release the brakes of every chained waggon.

--------

The couplers and size of the vehicle are now compatible with the Train Standards of the "Stormworks Rail Committee".

https://stormworks.gamepedia.com/Wiki/Standards/Land/Train