商店页面
Stormworks: Build and Rescue
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Stormworks: Build and Rescue

商店页面
Stormworks: Build and Rescue >  创意工坊 > BETO 的创意工坊 > modular ECU forced induction
modular ECU forced induction
描述 讨论0 留言9 改动说明
9 条留言
< >
Juna-Tah 10 月 21 日 下午 3:36 
So i connected all the parts together, i haven't touched the settings on the controller and the engine wont start, unsure what the "toggle" does, tried starting the engine with it both on or off and nothing, even tried removing the charger and that didn't work either.
RenTheOriginal 2024 年 9 月 16 日 下午 7:02 
I could not make any of my ships possible without your chip; thanks Beto!
BETO  [作者] 2024 年 5 月 23 日 上午 3:29 
On the same pipe as the air intake for the engine, but as of the space update this feature is not working, you should leave the node disconnected
Aviationist 101 2024 年 5 月 19 日 上午 10:38 
where on the engine do i put the pressure sensor
{TAH} TheGdog 2023 年 7 月 16 日 下午 7:49 
i have a twin turbo engine but the node only allows for one pressure sensor would it cause any problems if i dont connect one of them?
h13roglyphics 2023 年 4 月 11 日 下午 8:06 
where do i connect the starters to?
Cruise Plane 2022 年 7 月 22 日 下午 1:23 
i have a twin turbo engine but the node only allows for one pressure sensor would it cause any problems if i dont connect one of them?
BETO  [作者] 2022 年 3 月 26 日 上午 11:39 
to the boost pressure node on the ECU
Astropig_321 2022 年 3 月 22 日 下午 2:56 
what do you connect the pressure sensor to