Will this eventually get a Update?

Best Transport Aircraft i ever had in Stormworks

Atualiza pra a gente ai cumpadi

can you make it not outdatet or upload a new one?

Make landing gear not glitch at low physics

people gotta stop making these so damn complicated finding the start button to turn the damn thing on is a ♥♥♥♥♥♥♥ nightmare ive been looking for 10 minuets for anything not labeled lgbtq hot dog reader grandma shavings

agreed, it is broken. Many button do not work and many buttons for certain functions are nowhere to be found

creation is broken

is it normal for the landing gear to catch on fire when i toggle it?

This is a good plane, me and my friend has cruise the artic and principal isle in 10 minutes

Is this the same plane they used in the DLC tralier?

right

@CommonDrop_ Coordinates are entered in waypoint format the moment you type them on the keyboard. If you want to move from the old final destination to the new final destination, initialize the route before entering the coordinates on the keyboard.

it happens from time to time, but when i change the coordinate while the plane is on autopilot it will not change course

@CommonDrop_ As of now, there have been no problems with Autopilot. Please tell me in more detail.

auto pilot is broken will not go the the coordination i put in

@Turb0Punda The oil tank must be made separately. Or I'll make it separately later.

isnt kc supposed to be for tankers?

Amazing plane, any chance you could do a C-17?

good to see a plane from my contry in stormworks

great works!!
by the way, i think you did not connect between the monitor of radio console and MC. when you will update it, i hope to connect them

ok

@Capt_Epic
at the seat at the bunk crew
there is 2 mode, drop mode and ground mode :)

how do i open the cargo bay door

Then solve it by tilting the humvee over then launching it

winch doesnt working :(

this is good plane

aviões brasileiros... pog pra krl

Sounds good.. Thanks Dread!

@Buzz313TH Sorry for erasing your question. I don't have HOTAS, so I can't seem to be able to accept your request. Currently, there is no way other than controlling it with the keyboard. However, if you have any thoughts on testing HOTAS and plan to tell you how you want to control it, I will be waiting for your contact with Discord or SteamPM.

@Buzz313TH Sorry, I couldn't tell you right. It is located on the left side of the engine starter panel among the panels above the cockpit. Aircraft formation light and it's with NAV.

Thanks Dread... Where on the panel is the back light switch?

@Buzz313TH It's back light

I need help. For the life of me, I cant figure out how to turn on the Primary flight displays and monitors.

@wouterstoman I'll check. thank you.

CAN YOU MAKE A C 5

This is amazing, thank you. Can you please fix the bathroom mirror and the crew seat interactive map and instruments, they don't seem to do anything?

Love this. Small enough to not need to fold wings and tail and large enough that it can fit a default container with a bit of finagling. Also very much like the formation lights. I love formation lights :)

THIS IS SO OP!!! I LOVE IT!!!!! IT CAN HANDEL STRONG WIND IS WHAT I LOVE BRO! KEEP IT UP!

ok dreadway2.

i love it, because i love Embraers. Can you also make a Embraer 170

@Seawolf hmm..I have checked the pellets several times, but couldn't find the cause of the rapid discharge. However, if only the engine starter is turned on, it may cause electric discharge. Before using the pellets, turn on the APU (engine starter, fuel pump, electricity) before proceeding.

How do I use the airso pallets for this creation? and what size is recommended?

there was nothing on the pallet.

@Seawolf What cargo did you put on the pellets? If you are in a workshop, please provide the vehicle's address. Let's test it out and find out what's wrong with it. As of now, there were no battery discharge problems in my test vehicle.

@Alec Mesa It is currently normal that the altitude set value and the actual value are different. The cause seems to be insufficient PID value, and there will be an error between the set value and the actual value depending on the throttle condition. It's the oldest problem I've encountered while building an aircraft, and I'd like you to know that I'm still trying to fix it until the PID values ​​are satisfied, but I'm sorry for not being able to report this problem.

nothing would work.

hey, Dreadway2 when i conected the pallet to the floor of the plane i imedeetly lost all power to the plane.

The autopilot and avionics are in need of improvement in this aircraft. I have the AP altitude set to 150, the autopilot seems to want to maintain 134. Also noticed that the altimeter tape does not go up or down. Only the number changes. There's also no real documentation on how to start up and operate this aircraft. It's not hard to figure out but I believe a lot of people would benefit from some good written instructions.

Is a really good build

amazing it can tell when you have to jump to reach the target, here have the mad scientist reward.