Steam 社区 :: ENDAIR A321 Cockpit Module

商店页面

Stormworks: Build and Rescue

全部讨论截图艺术作品实况直播视频创意工坊新闻指南评测

Stormworks: Build and Rescue > 创意工坊 > EnderPilot 的创意工坊 > ENDAIR A321 Cockpit Module

ENDAIR A321 Cockpit Module

描述讨论0 留言19 改动说明

19 条留言

< >

EnderPilot [作者] 2024 年 4 月 1 日上午 4:56

Hello everyone!
yes the beluga loader has some problems that i will try to fix!

@CatLover2500
I would encourage you to make you own designs!

CatLover2500 2024 年 3 月 28 日下午 5:35

is it ok if we use it to build other plane types?

moatiey 2022 年 11 月 14 日下午 11:14

If anyone is having issues with the thing sliding, you have to backup the loader with the freight pallette then slide the a321 cargo on.

Oli 2022 年 11 月 14 日上午 7:07

when i put it on the beluga loader it just slides off when i drive

JaydenSKS 2022 年 9 月 18 日上午 10:56

Not even good

Seraph 2021 年 9 月 6 日下午 4:26

i'll try again later, but thanks for the advice!

Seraph 2021 年 9 月 6 日下午 4:26

ah i see

EnderPilot [作者] 2021 年 9 月 6 日上午 4:24

@Officer

Thanks for the feeback!
But sadly both the bugs are false

You have to spawn the module and the loader in
Then attach the module to the loader (Make sure the loader is retracted all the way down)
then unlock the brakes of the A321 cargo and slide it in the ramp,
Enable the brakes again and then extend the loader ramp fully,

The open the cargo door of the beluga and drive the loader into the nose of the plane (it should connect automatically)

Then you load and secure the cargo, disconnect the loader and drive away.

Seraph 2021 年 9 月 5 日下午 6:01

update on bug 1: the cockpit module iteslf does fit into the cargo hold, however as bug 2 states "the belugas cargo loader is too high from the ground" it will be extremely hard to take the module off of its palette then onto the ramp

Seraph 2021 年 9 月 5 日下午 5:58

how do you load this into the beluga? are you supposed to paste it into the cargo hold? anyway here are the bugs:

1. this cannot fit into the cargo hold of the beluga, i tried it out by pasting the module into the beluga and it would not fit

2. the belugas cargo loader is too high from the ground, making it impossible to load any type of cargo onto it

EnderPilot [作者] 2021 年 4 月 5 日下午 1:50

I Mean its for the Beluga!
I Specifically ask not to be modified
and the SW community is an honest place
with this logic you could easily cut and copy every plane in the Workshop!