商店页面
Stormworks: Build and Rescue
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Stormworks: Build and Rescue

商店页面
Stormworks: Build and Rescue >  创意工坊 > esa 的创意工坊 > Helicopter altitude hold
Helicopter altitude hold
描述 讨论0 留言7 改动说明
7 条留言
< >
esa  [作者] 2021 年 3 月 8 日 下午 11:44 
Okay, thanks for the feedback, I might do that at some point. Right now I really donä't have interest in Stormworks. But thanks for the feedback!:Khappy:
PinkTurkey 2021 年 3 月 8 日 下午 5:24 
mine does use two gyros to stabilize, so it could just be that
PinkTurkey 2021 年 3 月 8 日 下午 5:22 
very good altitude hold. one thing i would suggest is limiting the collective depending on how fast you are going. my helicopter runs off a propeller and a jet and it overshoots the target a little bit
esa  [作者] 2020 年 12 月 31 日 上午 5:04 
Nice to hear that this helped:)
vahgay 2020 年 12 月 30 日 下午 4:32 
THANK YOU IVE BEEN LOOKING FOR ONE OF THESE FOR SO LONG FOR MY CARRER HELI
esa  [作者] 2020 年 12 月 14 日 下午 11:02 
You put the up/down from the seat to the collective input and the collective output to the gyro and from the gyro to the rotor.
oHantuss 2020 年 12 月 14 日 下午 9:35 
Where do i put the collective input and output thats all Thanks