No electrics are connected

WARNING! Carry on Reading This! Or you will die! Even if you only look at the word warning! Once there was a little girl called Clarissa, she was ten years old and she lived in a mental hospital, because she killed her mom and dad. She got so bad that she went to kill all the staff in the hostpital so the More- The Government decided to get rid of her so they set up a special room to kill her, in the most humane way possible but it went wrong the machine that they were using went wrong. And she sat there in agony for hours until she died. Now every week on the day of her death she returns to the person who reads this letter, on a monday night at 12:00. she creeps into your room and kills you slowly by cutting you and watching you bleed to death. Now send this to 10 other profiles on this site, and she will haunt someone who doesn't. This isnt fake, apparently. If you copy and paste this to ten other comments you will have the best of your life.

when i try to move it explods

i cant move

pls fix pls this childhood to me

pls make the engines advanced and add batteries

HOW TO MOVE ????????????

how do i get it to move? i turned on the engines and i cant get it to move after putting the throttle all the way up

i cant get it moving

advanced plz

How the heck do I download it?

Hey man, just an idea for you, if you wanted the hot tub to fill with water, just make the topside of it a sealed door/sealed compartment, you could have this sealed door raise up like a roof over the hot tub, move to the sides, drop down as a floor, etc if you wanted it to fill with water!

adv pls

brillliant ship but please fix the swaying so the ship can be admired

Did Camodo use this?

Brilliant ship, what wold make it perfect is cruise control!

I found out, thx

you first need to enter the room and there should be a labeled button to open it

How do I open the small boats hangar?

I just had a lot of fun with this yacht. I managed to sink, and then raise it. I first made sure the bilge pumps were off, and then I opened every door, finishing with the Tender doors. I flooded all the ballast, and that was enough to weigh the boat down enough to get water into the tender area, and then gradually, the rest of the ship. I then raised it by closing all external doors, and pumping out the ballast and bilge.

This is the only ship I've seen so far on Stormworks that is able to be properly raised again after it's been sunk, and I'm going to go off and do that several more times now. :D

If only this could go underwater like a sub

I have seen some workarounds for the fluid update, but it looks like they may rework somethings soon. I'll see how fluid continues to work and update once things are figured out.

You can make other ships inside a ship, just need to make sure they are not merged together. The downside to this is you cant see the weight distribution and tweaking them is a bit more difficult.

I spent a couple of hours walking around this ship. The attention to detail and overall design is mind boggling. I also had no idea you could make vehicles inside another vessel which were actually usable.

Sadly broken with the fluid update. Water just hangs in a ball at the mouth of the turrets.

you could use the trim option to maintain speed by pressing alt. you would have to reset it for controls to retun to normal

Amazing, if only it could hold its speed so i could walk around while its moving.

Please make a emergency engine/generator for rp/ more power and speed if needed.

you could always add a hatch if you really want to sink it

the only way i have been able to sink it is by filling the tanks, turning off the bilge pumps, and opening the tender doors in rough weather

lol, i've been trying so long to sink it, does anyone know how?

https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=1391963481&searchtext=

Update.

Hangar has been redone to ease movement amd enlarged
More buttons and rooms have been labeled
left distance sensor has been fixed

Im really not surpsied the ship is difficult to sink. After I added the tender garage I redid the ships hull, when i did this I actually made it a bit too boyant. I then had to add a lot of weights to get it to sit in the water to my liking.

P.S the tenders do flip rather easily and have had the power levels lowered to reduce this

Update.. RHIB connectors now work, RHIB buttons are now labeled and working, added front connectors to all tenders, added lights to the sub, fixed a door, and adjusted depth red alert.

for me when using the sub i am able to turn and accelerate well to get it back to the ship. I have labeled the controlls for the sub it but please let me know if you keep having problems. Sadly to get the middle connector to float would greatly increase the size. What i normally do is turn of the connector on the ship and lower the winch just above sea level.

Ah great, also, fyi, the port tender's rear connector will not activate, and the rear button (both unlabled) does nothing, I recommend making it control the connectors. Also, this thing is beautiful, sure, the sub is finniky (cant get it to move unless deep underwater, making getting it back in hard. Also, the rear winches, if you can make the middle one float, and have a connector in front of each craft, you can tow one, so you can get the sub out. This is a masterpiece. second note, I cant sink it. Even with bilge pumps off, it is too fine a ship. It is not that I have actually tried, I mean I usually do, but I cant bring myself to do it.

sadly the way the garage was designed requires the speed boat to be launched first. It wasnt planned for at first and to do that would make the space a lot larger

Out of curiosity, how do I launch the sub without launching tenders?