Thanks Rob. :)

Am enjoying the series yo must have been busy to fo all the Series you have up will keep me occupied for a while

For some reason older scenarios get moved around each year the game updates. I've never made a free roam. Strange.

For some reason, this part is in the free roam section, not sure why

Saftey ropes! :)

Nice scenario RB!!!... Leaving Colfax behind... and now the climb truly begins...

Thanks Wolf. :)

Good scenario a fun run that is a bit different from the last part, with a bit of shunting. I like it.
Another good one for the collection.

Thanks & welcome wigbolts.

Very good. Thanks RB.

Thanks Rammy.

A Nice scenario relaxing drive and a small drop off at colfax not much traffic about. Thanks.

Very welcome N.C....Thank you.

i like this scenario thanks RB

Thanks henele54. trying to make the straight run scenarios feel more active with other AI and scenery.

Today I did part 3 and 4 of Leaving Roseville and enjoyed them both.

Thanks and welcome crlynch and Ken. :)

Another excellent step in this process. Will continue on tomorrow. Again, thanks for all your work.

Awesome bud off to do next one top marks cheers

Good to know. Any issues always let me know. Thanks.

What a difference those extra couple of yards made!! As you suggested I stopped with the last loco just past the signal and everything worked perfectly! Many thanks for your assistance RB, I'm glad to have been able to complete the scenario.

In the past on scenarios I have played, I always save after each task then any problems with the next task I just re-boot and clearing cache helps.

Stop the end just past the signal.

That is a possibility. I ran the train to 0.0 miles and did check the back to make sure the whole train was in the loop, but I will try it again later and run it further into the loop to see if that does make a difference.

The only thing might be that the very end of your consist wasn't on the siding when you dropped. Other than that I don't know. It worked fine for all 8 to 10 tests I ran.

I have attempted this scenario and everything works fine until the first drop off at Colfax. I dropped off the required cars in Colfax yard just retaining the one wagon as instructed. This would not then recouple to the stock left in the loop so I was unable to continue. I tried the usual trick of unsubscribing, deleting manually in the Build section, clearing the TS cache and then resubscribing but unfortunately the same problem occurred. I don't know if you have any suggestion as to what I am doing wrong.