Stormworks: Build and Rescue

Stormworks: Build and Rescue

41 个评价
SRX Reaper XS75 | 75 Ton Heavy Wrecker Rotator
   
奖励
收藏
已收藏
取消收藏
文件大小
发表于
更新日期
1.738 MB
4 月 24 日 上午 10:12
10 月 7 日 下午 4:51
13 项改动说明 ( 查看 )

订阅以下载
SRX Reaper XS75 | 75 Ton Heavy Wrecker Rotator

在 PsychoticPunk 的 1 个合集中
Fingo T-series Trucks
75 件物品
描述


This is the new SRX Reaper XS75. It’s a 75 Ton capacity heavy wrecker rotator designed and built in collaboration between Fingo Motor Co and SRX incorporated.

The Reaper XS75 is built on a fully optioned out tri-drive, dual-steer (5-Axle) Fingo TX9980 big hood heavy truck chassis, powered by a VForce 12i QMAX 755 horsepower turbo-diesel engine mated to an Eaton-Fuller 18 speed manual transmission. The engine also drives an On-Demand Live PTO that can be switched on to provide hydraulic power to all the wrecker body functions. This wrecker truck also features optional equipment such as an APU to power the sleeper and HVAC while resting, a heavy duty cattle guard, custom mesh grille, and side vents, drop visor, exclusive Fingo LED headlights, cab horns, and bull horn exhaust stacks. It even has a microwave.

In back, you have a full wrecker body with a fully functional ultra-heavy-duty 75-ton recovery boom that can telescope out to reach up to 55 ft up in the air, 180° total rotating range with 90° rotating range in either direction from center

The wrecker body also comes equipped with a fully functioning 80K tow capacity underlift that features two mag-alls to secure to the vehicle in tow, and a single electrical connector in the center of the under-lift head to offer a superior connecting method to the vehicle in tow. (it is highly recommended to equip the vehicle in tow with an electrical connector prior to towing as the mag alls will drop the vehicle easily)

On the sides of the wrecker body, you will find the 4-point extendable outriggers deigned for maximum ground stability when lifting with the recovery boom. For the best ground securement, extend and lower the outriggers with the mag-alls disengaged until they bottom out and begin to lift the truck, then engage the mag alls and raise the outriggers until they audibly secure to the ground.

The wrecker body comes with a fully array of storage cabinets on either side featuring general equipment, as well as adapters for the boom allowing it to secure to rope anchors and other hooks for any different recovery scenario that you may come across.

In conclusion, the Reaper XS75 is an extremely capable heavy wrecker that can and will handle any extreme recovery scenario you could come across.

Credits
SRX Incorporated
Fingo Motor Co

Components
Fingo TX 9980 Glider Kit
Eaton Fuller 18 Speed Manual Transmission
VForce 12 MAX 735 HP


If you find any bugs please report them in the comments. We will be actively working to patch any bugs and improve features and functions. Thanks.

DO NOT RE-UPLOAD THIS CREATION

Keywords – Heavy, Wrecker, Rotator, Tow Truck, Towing, Recovery, Turbo Diesel, Big Hood, APU, Underlift

28 条留言
PsychoticPunk  [作者] 6 月 1 日 下午 10:32 
Thanks bro
sarobertson7 6 月 1 日 下午 9:18 
Looks amazing!
Crazycat123 5 月 20 日 下午 2:52 
You should make just a plain old tri drive. Btw very good truck
Rex  [作者] 5 月 4 日 下午 6:18 
Thanks
PsychoticPunk  [作者] 5 月 3 日 上午 8:18 
Thanks bro
But Hull 5 月 3 日 上午 2:58 
Very nice truck
PsychoticPunk  [作者] 4 月 30 日 下午 1:12 
To get the outriggers to grip you have to lower then down without the mags on and then when they bottom out you turn the mags on and pull them back up until the mags secure
swedishzakes 4 月 30 日 下午 12:29 
i also have it pop a wheeli
swedishzakes 4 月 30 日 下午 12:24 
sorry for my bad english
swedishzakes 4 月 30 日 下午 12:24 
the outside mag alls wich drags the inner to tho too make sence i was holding it on the side so that might have something with it