商店页面

Stormworks: Build and Rescue

全部讨论截图艺术作品实况直播视频创意工坊新闻指南评测

Stormworks: Build and Rescue > 创意工坊 > Marcotics 的创意工坊

评价数不足

Automatic Crab Trap

描述讨论0 留言18 改动说明

奖励

Vehicles: Vehicle, Sea, Underwater, Stationary, Subassembly, Advanced, Fishing

标签： v1.15.4

文件大小

发表于

更新日期

34.490 KB

2024 年 8 月 14 日下午 6:28

10 月 5 日下午 3:06

4 项改动说明（查看）

3,162	不重复访客数
1,333	当前订阅者
27	当前收藏人数

订阅以下载
Automatic Crab Trap

已订阅

取消订阅

描述

Simply attach to ship via the electrical connector. Crane it using the same connector.

Once it is disconnected, it will auto deploy and anchor itself to the seabed, and auto extend the rope to the depth of the water it is deployed in (max length 40m).

To remove it from the ocean, simply reconnect to the electrical connector, and the assembly will retract back to storage position.

When deployed:
-Transponder activated, so it can be easily located again.
-Orange light on the buoy, which changes to green when at set fill level (default 1).
-Auto recharging batteries via solar panels.

18 条留言

< >

Marcotics [作者] 10 月 11 日下午 1:47

Awesome, glad to hear.

possiblylucas0680 10 月 11 日上午 8:26

thanks! it works very well

Marcotics [作者] 10 月 5 日下午 3:09

Make sure you replace the sub-assembly on your ship if you have it there, since it has been updated.

Marcotics [作者] 10 月 5 日下午 3:08

Thanks for helping, that's awfully nice of you.

I found the issue. The winch was attempting to winch up but it was also still trying to winch down from the initial deployment. I updated the logic to check if the connector was NOT connected and disable the winch down after the delay.

I tested it and it seems to work now. Thanks.

CAT_OPS 10 月 5 日上午 4:00

Or, can we ask what you used to pull it out? Just a normal crane with an electric connector?

CAT_OPS 10 月 5 日上午 3:27

I mean, should we connect something in the composite logic?

CAT_OPS 10 月 5 日上午 3:27

PossiblyLucas0680 and I tried to work on this together. It really doesn't retract after lifting it out of the water. We used an electric connector, and we make sure that we supplied power to the connector on our crane, and lifted the buoy out of the water using the crane and connector, and it still didn't retract. Should we connect some sort of composite connectors?

possiblylucas0680 10 月 4 日上午 6:33

but when i get it out of the water it doesnt

Marcotics [作者] 10 月 3 日下午 7:57

No. You have to get it out of the water to retract.

possiblylucas0680 10 月 3 日上午 9:35

how does this work? idk how to get it to retract

< >

Stormworks: Build and Rescue

订阅以下载Automatic Crab Trap

编辑链接

订阅以下载
Automatic Crab Trap