Stormworks: Build and Rescue

Stormworks: Build and Rescue

评价数不足
[Rythena] Mirage IIIDE JATO
   
奖励
收藏
已收藏
取消收藏
文件大小
发表于
190.741 KB
2024 年 7 月 16 日 下午 7:08
1 项改动说明 ( 查看 )

订阅以下载
[Rythena] Mirage IIIDE JATO

在 Cailean.Coleman 的 1 个合集中
Rythena Marines
108 件物品
描述
Slap this on the Mirage IIIDE rear hardpoints near the back wing roots to allow for JATO takeoffs!


When performing a JATO takeoff make sure to get to a high speed taxi throttle and then flip the JATO switch, upon doing this raise the throttle to a low speed cruise and watch as you get lifted off of the ground and into the air! The JATO rockets will release when burnt.
11 条留言
Cailean.Coleman  [作者] 2024 年 10 月 8 日 下午 5:20 
a 57 may come one day
amcervantes80 2024 年 10 月 8 日 下午 3:41 
Can you make a SU-47
Cailean.Coleman  [作者] 2024 年 8 月 6 日 上午 6:48 
yay thx!
Goose 2024 年 8 月 6 日 上午 6:32 
super cool build
Goose 2024 年 8 月 6 日 上午 6:31 
i figured it out tysm
Goose 2024 年 8 月 5 日 下午 6:43 
hm, ill try and figure it out
Cailean.Coleman  [作者] 2024 年 8 月 5 日 下午 4:03 
furthest back
Goose 2024 年 8 月 5 日 下午 2:46 
is it ment to attach to the farthest back wing hardpoint?
Goose 2024 年 8 月 5 日 下午 2:33 
that would be nice cause im just confused,
Cailean.Coleman  [作者] 2024 年 8 月 5 日 上午 8:13 
ah sorry it is a tad hidden. so if you look at the jato you will notice a circle next to the pivot on the jato, That is the hardpoint. align the jets JATO hardpoint with the little circle and you should be good. Ill add an extra screenshot to if there is any confusion.