订阅以下载
Clair de Lune

However, you can write your own program for it to play.

If you do want to make it play your own song, you will want to write it in notepad first. A picture of the full song is included in the vehicle photos, it is written twice; once separated out into measures and then underneath combined into 128 character strings so it fits in the text properties for the controllers.

Every comma represents the end of a single unit of time, anything right before a comma will play on that unit of time:

q,q,q,,

This is the same as two middle C quarter notes and then a half note, as you can see by the commas. If you want to lift the pedal, put an underscore along with the note, like this:

q,q,_q,,

This will allow the pedal to be depressed for the first two notes, but on the third note the pedal will lift and then depress once again before the note is over. It is like how you would lift at the end of a measure.

If you want to play chords, just put multiple notes into one time slot:

qti,qti,qti,,

This will play a C chord in two quarter notes and then a half note.

The key for computer keyboard to piano keyboard is included in the images. The middle player plays from middle C to the b natural right under the second C up, it includes two octaves, 24 notes in total. The left player plays from the b under middle C to the second C down, another two octaves. The player on the right plays from the second C up and onward, up to the limit of the buzzers which is the d flat after the third C.

On this website[www.szynalski.com] the bottom player spans from C2 to B3, the middle spans from C4 to B5, the top spans from C6 to C#7 (the note not the chord).

The sustain property will enable/disable the pedal. (It sounds like a small pipe organ when it's disabled)

The ticks per sample property controls how long one , is. This is how you control the tempo.

samples per sustain is for if you want to automatically periodically reset the pedal if you don't want to manually add in the underscores into the program.

If you accidentally delete a character from one of the programs, good luck figuring out what it was.
Don't select any of the buzzers, doing so will reset them back into their default bounds set by their property sliders. You will have to reload the vehicle from the save to restore it.

If you want to change the buzzer type, open the vehicle's xml, edit, replace and then type in the name of the seat belt buzzer and replace it with the name of the buzzer you want. It will not be in the right key, as every buzzer is centered on a different note, but it should technically be in tune. (beep2 is very cute)

The red buzzers and lights are technically functional but are all the same tone, the maximum possible. I left them as a visual indication for if the inputted program exceeds the bounds of the buzzers. The lower bound of the buzzers is only one note past the current lowest note, so I didn't bother adding it as it would need its own full controller.

If you want to use the "Stoneway" piano as a prop on one of your builds go ahead, just make sure to credit

The program loaded into the piano as default does sound a little robotic, as it is direct 1:1 the sheet music for Clair de Lune, from here.[musescore.com] It doesn't have any emotion ingame aside from some slight pauses.

If you hear some weird buzzer sounds most likely it's because of the amount of buzzers the audio has to layer at one time. The game doesn't do too well with the massive chords and arpeggios, especially when the pedal is active.



like comment subscribe and i will play clair de lune on the moon (no clickbait) *gone wrong* [she cries] SCARY! *3AM* (GONE RIGHT) [GONE WRONG] (not really)