Stormworks: Build and Rescue

Stormworks: Build and Rescue

76 个评价
Zizo's Radar & Sonar Map (Updated)
3
   
奖励
收藏
已收藏
取消收藏
Vehicles: Air, Sea, Land
标签: v1.11.2
文件大小
发表于
更新日期
143.927 KB
2024 年 6 月 2 日 下午 12:00
2024 年 6 月 5 日 下午 2:39
4 项改动说明 ( 查看 )

订阅以下载
Zizo's Radar & Sonar Map (Updated)

描述
This system draws Radar and Sonar detection on map, to easily locate any object in Stormworks.
This is the updated version to work with the new sonars and radars.

Features
  • Radar & Sonar on one display, with detection projected on a map for easier spotting.
  • Displays relative altitude (H) of the targets.
  • Complete touchscreen controls, intuitive UI.
  • Various map coloration theme settings to choose from.
  • Compatible with most monitors sizes.

Installation
  • Look for "Radar Map V2" microcontroller in the inventory.
  • Just connect all logic nodes, make sure all sensors are placed as shown by the images.
  • Radars must be rotating clockwise
  • Narrow FOV X or high sweep speeds reduce the ability to detect small targets of the radar.
  • Make sure you change the radar range in the microprocessor to match the one of your radar.
  • For best accuracy of height measurement, place the physics sensor as close to the radar as possible.

Usage
Complete touchscreen controls
  • R: activate radar
  • S/P/A: activate sonar & switch sonar modes (Off, Passive, Active)
  • +: zoom in
  • -: zoom out
  • 1/2/3: switch between map coloration theme modes
  • Targets: hold touchscreen on the green and blue dots to display relative altitude (when avaiable).

Setup
The microprocessor offers various customisations:
  • Radar Range: change this according to what your radar estimated range is.
  • Sonar Type: choose between large and small sonar or disabled.
  • Display: switch between displaying full map or circle.
  • Default map mode: choose the map mode selected at spawn.
  • Map Color 1: choose your map coloration theme when in day mode
  • Map Color 2: choose your map coloration theme when in night mode

Join my discord for support[discord.gg]
44 条留言
RedneckRepublic 9 月 5 日 下午 2:24 
Hey Zizo, any possibility of being able to get rid of the grey surrounding ring?
AeryToast 8 月 25 日 下午 1:07 
is there any way to filter out fish from the sonar?
liam.limb0 8 月 20 日 下午 4:54 
9x5 monitor time!
Frag2000 5 月 15 日 上午 3:42 
Very strong generic component. Easy to use and configure. Great work! As constructive criticism, I would add a small mute button on the display for the buzzer. Even though the buzzer function is right, is gets annoying of very long run. It would be nice to be able to shut it down when not needed. I will add it in your controller, but I think that it is the only thing really missing.
Niion autumn 4 月 28 日 下午 3:55 
OK, so i found out by messing around with the physics sensor that it MUST be in the upright position as shown in the photo. NOT laying on it's side or upside down!! otherwise the radar sweep will go all jumpy on you. i hope this solved your radar issue with your awesome creations.
Noah_torrres0625 4 月 9 日 下午 6:59 
I'm letting you know that im going to post a boat that i built using your micro controller for its radar.
I'm crediting you and putting a link down to your creation thank you!
Zizo  [作者] 3 月 13 日 上午 5:14 
Hello @Doughy_Hamboney, it works on all the monitors but I advise against 1x1, 1x2 and 1x3, they are too small to display all the relevant information and GUI.

Hello @Jax_the_wolf, if you mean if this will detect missiles, it does but there are more effective ways for detecting them.
Jax_the_wolf 3 月 12 日 下午 2:11 
can this work is a missile radar?
Doughy_Hamboney 2 月 27 日 下午 5:23 
What types of monitors can this work on? i remember something about 1X1 and 2X2 monitors but would it work with 3X3 monitors? Also i feel like there should be a mode for sweeping radars
Sleeper____ 2 月 26 日 下午 3:01 
Okay. I tested it with just the Sonar and it worked fine too.