订阅以下载
RC-135 "Rivet Joint" Reconnaissance Aircraft

Basic Controls

To board the plane, approach the side button and press it.
Look up at the handle and walk toward it.
While looking at the handle, press either 'E' or 'Q'.
Look down, hold 'W,' and release the handle when you are inside the plane.
Close the door and proceed into the cockpit.

---

Startup

Turn on the Avionics button.
Activate the fuel pumps for all four engines.
Hold down the engine starters for each engine; you can start in any order.
Wait for the engine RPS to stabilize.
Hold '1' to throttle up both throttle levers.
Set the RPS to 30 for takeoff.
After becoming airborne, press the Landing Gear button to retract the landing gear.

---

Weapons Operation

Press the Arm Weapons switch to arm the missiles.
You can fire either bay missiles or external missiles.
To fire the bay missiles, press the Open AGM bay button, and then press the Drop AGM button.
To fire external missiles, press '4' after arming the missiles.

---

Radar Usage

After turning on the Avionics, you can use either the Search Radar or the Sweep Radar.
To use the Search Radar, press either 'E' or 'Q' on the screen labeled "OFF."
To use the Sweep Radar, turn on the Sweep Radar switch and use 'E' or 'Q' to change the sweep radar distance.

---

Self-Destruct Sequence

Locate the key on the left wall behind the pilot.
Turn the key to initiate the self-destruct sequence.

---

Credit to MrNJersey for the heater and map mc, credit to vladd for the radar map controller mc, and credit to newquay for the sweep radar (message me if i forgot to credit you)

Special Thanks to Golathe for making the landing gear