商店页面

Stormworks: Build and Rescue

全部讨论截图艺术作品实况直播视频创意工坊新闻指南评测

Stormworks: Build and Rescue > 创意工坊 > Uran_Wind 的创意工坊

39 个评价

ZE Modular Clutch

描述讨论0 留言17 改动说明

奖励

Vehicles: Mechanical

Microcontrollers: Modular, Microcontroller

标签： v1.7.4

文件大小

发表于

更新日期

46.507 KB

2023 年 5 月 10 日上午 2:40

2023 年 5 月 11 日上午 1:50

2 项改动说明（查看）

6,035	不重复访客数
3,555	当前订阅者
55	当前收藏人数

订阅以下载
ZE Modular Clutch

已订阅

取消订阅

描述

Don't insert extra logic gates between the RPS and clutch nodes.

A standalone controller for the modular clutch taken from the drivetrain controller. Compatible with geared and continuously variable transmissions.

Heavily relies on stable engine RPS and low tick delay between RPS and clutch nodes.
The clutch will be fully engaged if the engine RPS reaches the threshold RPS value set in controllers properties, and if the throttle axis value will be 1. If you need to dynamically change the RPS threshold, replace the static property number with numeric node.
Decrease the clutch sensitivity slider if RPS starts to jitter, or increase it if the RPS drops too low while accelerating.

17 条留言

< >

YummyCookieYT 6 月 4 日上午 1:17

@Compu There's three solutions that I've found that've helped.
1. Decrease the amount of power your engine generates - the more power your engine generates, the more the RPS will jitter. Consider using a more lean AFR, lower engine RPS, decrease cylinders, etc.
2. Place a dial onto your creation, read, at whatever clutch value your RPS jitters, and use a clamp on the clutch at 0.02 or 0.05 clutch lower should solve the issue. Since you're limiting your clutch- you can then increase the gear ratio toward your engine and it shouldn't jitter since it's clamped at where it used to jitter.
3. Go into the Clutch Controller and manually set the minimum value to a negative number. The clutch controller will still work and should resolve your issue. If it doesn't fix it consider using a different clutch.