订阅以下载
Baldwin Locomotive Works #26 Shop Switcher

This is a recreation of Baldwin locomotive works #26 Wiki link--->https://en.wikipedia.org/wiki/Baldwin_Locomotive_Works_26
Before you start, You need to know the Basics of a steam locomotive! A regulator is what regulates steam to the pistons allowing you to move. The reverser Is what allows your locomotive to reverse when given regulator. The Damper controls the heat of the firebox, while the blower uses steam pressure to create a better draft. The compressor valve is on the left side in front of the fireman's seat.


Ignite the firebox and make sure you fill it with coal!


Make sure the Injector is started using the hand pump on the floor behind the drivers seat

you will begin to build pressure. Once you get 1.0 pressure turn on the dynamo.
you will then begin to gain lighting(change headlight status on the top right above the engineer)


1. Flip the realistic firing switch and the ignition switch
2. using the panel to the left, raise the "Damper" all the way up to 1, the damper should stay like this until you want to shut down the locomotive
3. open the "Blower" to half, this uses steam pressure to create a draft in the fire.
4. Continue to shovel coal into the firebox
5. Once at least 1 pressure has built up, continue to the next steps

STEAMING UP

6. Open the "Dynamo" Valve located on the left front upper corner of the cab to turn on the lights.
7. continue to shovel coal and build pressure

ONE MINUTE FROM DEPARTURE
(preparation for departure)

8. turn the "blower" to 1 to build fire temperature to avoid pressure loss on departure. Do not worry about pressure possibly exploding the boiler, the safety valves are able to dump more steam than the boiler can physically create.
9. Once you are ready to go and you are at full pressure, turn off the blower.

If you are using custom signals with custom frequencies. Switch the signal under the the tender on the left side.


Cheesy made this, I just helped with the marketing, and had to upload it for him due to technical difficulties, we recently started collaborating on a lot of stuff, so expect some big things soon! (And check out cheesy’s other workshop creations if you liked this one) If you have any questions or comments about this creation, feel free to comment down below!
- Corey.Deuso


If you love to see people working on projects or just want to be notified when one comes out check out Endoskull gaming on discord. Hope to see you there!
-Cheesy