Stormworks: Build and Rescue

Stormworks: Build and Rescue

评价数不足
LTV - Heavy Armament Carrier
   
奖励
收藏
已收藏
取消收藏
标签: v1.7.1
文件大小
发表于
更新日期
622.850 KB
2023 年 2 月 12 日 下午 2:45
2023 年 3 月 25 日 下午 12:47
3 项改动说明 ( 查看 )
您需要 DLC 才能使用该物品。

订阅以下载
LTV - Heavy Armament Carrier

描述
This is the Heavy Armament Carrier variant of my LTV series. It and all the other ones are based on the LTV from Call of Duty Warzone 2.0. It features custom side doors, a tailgate, working radio, automatic transmission, refueling capabilities, and adequate protection from small arms fire: eg. 20mm autocannon, Smg, Rifle, and Pistol rounds, as well as mediocre protection from c4 (that as in, it might immobilize the vehicle but it will not kill you). Featuring up to two layers of weight blocks (armor) surrounding the drive train (engine) and cab (seating area.) This variant also features 1 turret on top.

Things to look out for:
-The side doors may occasionally get stuck, simply press the button to open them and press it again. This happens due to part of the door being slighty unballanced via the truck being on a slope ect.

-Upon startup, do not hold W. Allow the engine to start first, and then you may drive.

-Holding S for around 1 second will engage the temporary brakes, these slow it down rather quickly. The brake is not permenant, and lasts 1 second before disengaging so you can go in reverse. Press 4 to engage p brake.

This variant should not be rammed into the side of a building going full speed. Despite the armor, this will destroy the engine because stormworks physics are not the same as real life physics. Go slowly down real steep slopes especially if the bottom of it turns upward at a rapid angle.


Startup instructions:

-Upon spawning in the vehicle, open the driver side door (the one on the front left), this will be where the drivers seat is located.

-Hop in the drivers seat, in the middle of the console is a button to control the heaters, if in the arctic this should be the first button pressed. You may also fiddle around with the interior lights located in the middle of the console, they are labeled for ease of use.

-Press and hold 6 for around 1 seconds, the engine should startup. It is important not to continue holding 6 after you hear the startup noise. The engine RPMs will start to go up, then they will go down, it may seem like the engine is stalling out but dont worry, it will recollect itself. (Happens occasionally depending on temperature.)

-Then, press 4 to release the parking brakes.

You are now good to go, hold down W for throttle, hold down S to slow down/and once stopped, to reverse. Hold/press A to turn left, and hold/press D to turn right.

Hold the 2 key for about 1 second to turn on and off the headlights.

Thank you for subscribing!

-- Turret instructions:

-Once in the turret, a and d is left and right. W is aim down. S is aim up. If these feel inverted to you, just go in the logic and connect what was connected to W to S and S to W.

-Press 1 for mouse aim, note this is a WIP and is very VERY sensitive. The turret will spin out of control if you continuously aim left or right. Aim the opposite direction to stop the turret. Press 1 to turn off mouse aim.

---Special thanks to Duckbill Core for fixing my noob engine design xD.

---Note: the trailer in the last photo is not mine! Hence i will not be uploading it. I only used it to demonstrate the trailer pulling capabilities of the truck (its got a lot of torque lol)