商店页面
Stormworks: Build and Rescue
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Stormworks: Build and Rescue

商店页面
Stormworks: Build and Rescue >  创意工坊 > fuzzymonkey11 的创意工坊
评价数不足
Dual Anchor Controller [DEPRECATED]
描述 讨论0 留言0 改动说明
   
奖励
收藏
已收藏
取消收藏
Vehicles: Sea, Mechanical
Microcontrollers: Microcontroller
标签： v1.6.13
文件大小
发表于
更新日期
343.180 KB
2023 年 2 月 7 日 上午 8:49
2023 年 2 月 8 日 下午 12:44
4 项改动说明 （ 查看 ）
创建者
fuzzymonkey11
离线
103 不重复访客数
20 当前订阅者
1 当前收藏人数

订阅以下载
Dual Anchor Controller [DEPRECATED]

描述
Dual Anchor Controller [DEPRECATED]
New Version!
I recommend you use my new version that uses a 2x2 display

New Version available here!







Properties
Type of winch | Needed to determine if an anchor is possible
Distance from mag all to distance sensor (m) | eg if laser sensor is 2m below mag all set value to -2. If it is 1m above set value to 1

IMPORTANT NOTE:

This controller has the feature of adding an altimeter to its data.
It is OFF by Default.
This is set in the properties of the controller.
Additionally you need to set the desired altitude in the properties.
The best way to find your desired altitude is by setting wind to 100% and setting the desired altitude to 0.
Ideally you want the boat to be relatively level doing this. If the bow of your boat is too low then increase the desired altitude and visa-versa.


Composite In

Channel
Type
Function
Channel 1
On/Off
Drop Anchor


Composite Out

Channel
Type
Function
Channel 2
Number
Average Winch Length
Channel 3
Number
Depth from sensor on boat to bottom of ocean
Channel 4
On/Off
Anchor Length > Distance to Bottom
Channel 5
On/Off
Left Anchor attached to bottom
Channel 6
On/Off
Right Anchor attached to bottom


If you use this be sure to credit me in your build and leave any comments / suggestions below!