商店页面

Stormworks: Build and Rescue

全部讨论截图艺术作品实况直播视频创意工坊新闻指南评测

Stormworks: Build and Rescue > 创意工坊 > Uran_Wind 的创意工坊

80 个评价

ZE Wheels Steering

描述讨论0 留言26 改动说明

奖励

Vehicles: Land

Microcontrollers: Microcontroller

标签： v1.6.7

文件大小

发表于

更新日期

52.635 KB

2022 年 11 月 15 日上午 8:56

2022 年 11 月 20 日下午 8:13

5 项改动说明（查看）

8,031	不重复访客数
4,894	当前订阅者
104	当前收藏人数

订阅以下载
ZE Wheels Steering

已订阅

取消订阅

描述

A controller for the wheel steering with dynamic reduction, optional angular stabilisation, and optional Ackermann steering.

Steering non-linearity is a modifier for the steering axis. The larger the value of the slider, the slower the steering value increases and the faster it decreases compared to the unmodified axis. Combine it with the adjustment of seat axis sensitivity to get the most comfortable steering curve.
Dynamic reduction changes the steering axis multiplier in range between the min and max steering sliders, depending on current speed. Reduction starts at the speed threshold for max steering and becomes full at the speed threshold for min steering in m/s. If you don't need the reduction, set the min and max steering sliders to be equal or just don't connect the linear speed node.
If you don't need the angular stablilisaiton, set the stabilisation sensitivity slider to 0 or just don't connect the nodes for angular speed and reverse.
For the Ackermann steering you should set the correct wheelbase length and track width of your vehicle in number of blocks. If you need multi-axle steering, duplicate the function gates with formulas for Ackermann steering with the same node inputs, and specify the corresponding wheelbase length for every extra axle.
Move the vehicle's center of mass forward for better cornering control.

Demo example.

26 条留言

< >

systemerror414 9 月 13 日下午 12:11

May God bless you from now until the end of time.
I was going crazy because of the steering but now i finally have a car that doesn't spin out of control when i drive slightly faster.
Thank you.

CatWithABat 1 月 30 日上午 9:43

Understood

Uran_Wind [作者] 1 月 24 日上午 2:43

No, it is not inverted. Correct steering direction is set for the wheels that both have the negative toe for positive steering value number, as it is the most intuitive way to install the wheels with suspension in symmetry mode. You can invert the steering axis input value, or if you are using the wheels without suspension, you can just rotate them 180 degrees.

CatWithABat 1 月 23 日下午 7:25

It appears that the steering is inverted, how do I change it?