订阅以下载
Challenger 2 (Dorchester 2F) [Weapons DLC] [Scale]

The Challenger 2 (2F) improves on a lot of the Challenger 2's weaknesses, particularely against shaped charge warheads through extensive ERA and slat armour placed along the hull and turret. This challenger 2F features one of the best fire control system's I've made thusfar, with the special inclusion of a tracking radar that automatically adjusts for target distance and movement, and the inclusion of a commander-override, meaning the commander can control the turret and gun without needing to switch seats.

---

Information:

• Fully Stabilized (2-plane) Cannon
  
• Top speed of 60km/h
  
• Automatic transmission with neutral steering
  
• Radar tracking targeting
  
• Commander-override targeting
  
• Supplementary laser rangefinder
  
• 4 Crew

---

How To Use:

1. To drive, enter the drivers seat, ensure power is on, and turn the key
   
2. Use W/S to accelerate, A/D to steer

1. To use the gunner's seat, press space to open the breach to load a round, then press again to close and fire the main cannon.
   
2. Use W/S to adjust gun elevation and A/D to adjust turret yaw
   
3. The yaw speed of the turret is dependent on the gunsight zoom, adjusted using the Zoom Toggle on the control panel
   
4. The tracking radar is enabled on the side panel. Simply lay the gun on your target while it's enabled and it will track the target with the correct range dialed in already. use Left/Right to adjust tracking for leading a target
   
5. The laser rangefinder outputs the absolute distance from where the gun is layed and it is displayed next to the button on the side panel. Inputting any number other than '0' on the keypad above the gunsight will adjust the gun to that range

1. To use commander-override, grab the remote control to the right of the commander's seat and set it to '4'
   
2. Press the 'Commander Override' button on the righthand side and enable the controller
   
3. Press '1' to operate the gun, and '2' to adjust the gunsight zoom. Note that the numerical buttons are toggle mode, so double press them.

---

This vehicle uses no XML modifications, and is entirely vanilla. Please enjoy :)
This vehicle is nearly 1:1 scale. It's size will be accurate against other scale vehicles

Thank you LoggerC4 for much of the exterior design and enhancing the driving[i.imgur.com]experience!