订阅以下载
PFD-300 Autopilot Integrator

This module displays autopilot information on the PFD-300. It works with any autopilot that uses heading, altitude, or airspeed information selection. It does not need to have all of these capabilities as it supports each one individually.

This microcontroller has a 4x2 footprint and 8 nodes.

Inputs
- Number inputs for the desired heading, altitude, and speed.
- On/Off inputs for heading, altitude, and speed bugs
- Composite input for use with additional add-on module

Outputs
- Composite output that goes to the PFD-300 controller.

Connect your target heading, target altitude, and target speed values to the number inputs. Select what units are being used as inputs in the microcontroller properties. When an on signal is sent to the respective input, it will display the targeted value on the PFD. Connect the composite output to the PFD-300 controller. You can connect the Command Bar Module to the composite input if you are using that as well.