订阅以下载
EMP IND Dreadnoughtus MKI

The Dreadnoughtus is a Mars Class Locomotive, Mars Class being multi track locomotives that serve as both an engine and a freight transport, essentially a Ute.

There are a few important things to note about the Dreadnoughtus, First of all, the clutch, set it to around 30, it wont slip and will go a lot faster... I don't know why, but cant argue with results

As for the Boiler, id recommend playing with it for a bit, getting a feel for the autistic PID of mine, it usually runs at about 1.5 less than the value you enter, say, you set it to 5, it will boil at around 3.5. A little trick on startup, set the boiler to 7, then as the dial for boiler pressure rises to around 8+ and the fluid level dial starts dropping, set it to 10, then once it settles, set it to 11, which should sit the boiler pressure to 9.8, it will almost hit 9.9, but stop just short... should atleast, just play around with it and get a feel for how it works.

Finally, id recommend just running about in high gear since generally, theres no point in using the low gear - high torque drive unless your carrying a fair bit or are just trying to move around carefully, also, theres a numpad to the right of the driver position, set the speed you hope to reach there, its in m/s so set it to around 40, as the top speed is generally far higher than that as the steam builds and the turbines climb, but any faster and funny physics happens.

Your going to need an XML edited station to spawn it, Id recommend the mega island north port station. which is Tile 9_8, theres plenty of tutorials on how to find the various Tile XMLs and how to edit them, this applies to all workbenches.

heres a tutorial on how to XML edit your workbenches https://www.youtube.com/watch?v=dQw4w9WgXcQ&ab