Stormworks: Build and Rescue

Stormworks: Build and Rescue

评价数不足
Reactor to Melt Down
   
奖励
收藏
已收藏
取消收藏
标签: v1.2.1
文件大小
发表于
153.774 KB
2021 年 5 月 28 日 上午 6:11
1 项改动说明 ( 查看 )

订阅以下载
Reactor to Melt Down

描述
A functional reactor that doesn't connect to anything as its purpose is to melt down. Good if you want to see what a meltdown is like without building your own reactor. Simply engage the reserve power breaker, lower the fuel rods, and wait. Features a radiation display and an evacuation alarm that will trigger when the radiation exceeds safe levels.
5 条留言
KernelPone  [作者] 2021 年 7 月 6 日 上午 5:59 
Make sure the control rods are all the way up. When I built it it would explode, but I haven't used or tested it since I built it and I don't know if the devs have changed anything with reactors. It should be noted that when it has a "meltdown" it will explode and radiation will spike but that's about all. The reactor itself will still be intact.
joe_frearson 2021 年 7 月 6 日 上午 5:30 
Do they eventually actually melt? Radiation got up to about 85 then started going down on its own, I'd hoped for an explosion or something haha
ThatOneDude 2021 年 6 月 11 日 上午 6:00 
I know. I was just telling people that and the alarm stayed in the whole time untill it dipped below 1 and then it turned off
KernelPone  [作者] 2021 年 5 月 30 日 上午 4:50 
When that is the case either the radiation has returned to safe levels or the battery has died. Either of which I consider to be fine. The purpose of this is for people who don't want to build their own reactor but just want to see what the reactor having a meltdown is like. It wasn't intended to be a long term solution to playing with the reactor, just a way to watch it blow up.
ThatOneDude 2021 年 5 月 29 日 下午 2:27 
You do realize that if you disengage the fuel rods the radiation peaks at 88-ish and the slowly goes back down and the alams go off.