订阅以下载
CH-106 "Seagull" Water Turret Attachment

Additonal Water turret for CH-106 "Seagull" Helicopter.

How to use it? Just use Selection Grid tool to paste it into workbench with CH-106 "Seagull", and thats it.

How to use selection grid tool? Follow this steps!:

1. In workbench upper right corner is selection tool, select it.
   
2. On left Toolbar select "Load Content"
   
3. Go to Workshop tab
   
4. Select attachment
   
5. On left Toolbar press "Paste"
   
6. Done!

It will automatically connect to it on spawn.
When Disabled it will switch back to main PFD.
It will display instructions on main PFD when connected. but...

Here are controlls anyways:

• WASD - Aim
  
• Up/Down - Zoom
  
• 3 - Fire turret
  
• 4 - Deploy
  
• 5 - Night Vision Mode

It will automatically disable if you are too close to solid ground/vehicle underneath and you need to enable it again.

Also it will automaticaly suck in seawater when you dip end of frame in it.

It's recommended to switch controlls to Joystick mode when using cannon, it will make it more responsive, press "J" and small controller will appear on right side of screen, it will make seat 100% responsive with keyboard.

Check out other addons for this helicopter to make it even more verstitile!
https://psteamcommunity.yuanyoumao.com/workshop/filedetails/?id=2370394544

Comment in that collection for addon you would like to see and i will see if it's viable.