订阅以下载
YV6 - V/STOL

This is a maneuverable jet that can also fly in VTOL & STOL mode, with a topspeed of 226 m/s or 440 KTS. Apart from being able to VTOL, it also have 2 internal weapon bays with space of 3x3x17, which is ideal for stealth or just a surprice attack. Inside the cockpit are luxurious displays and easy to read buttons as well as controls, and in case of an emergency, the jet also have an ejection seat.


Upon spawning you may notice it only spawns with internal missiles (R20A), but for external missiles or fuel tanks, they are needed to be placed manually, but are already made, so you just paste them in with selection tool and done.

In the seat you can read the seat controls [H], that also explains the seat buttons.
To start the engine, it's done by increasing the throttle lever by hand or by pressing [Up arrow/Collective].

To your right side at the front of all the buttons, there's the switch to "Release parking brakes", so you can start moving. Also to the right side are all the switches for light and to enable "MFD power" (The 2x2 monitor), as well as the button to arm the pylons, to enable firing the missiles or jettison the droptanks by [4] when selected.

When started it won't shutdown even with the throttle to 0, but that makes you have better control for taxing the jet, as you can steer by yaw, and if you keep pressing down [Down arrow/Collective] it will enable variable brakes to slow down, giving you a lot of ground control.

To shutdown the jet engine, you set the throttle to 0, and make sure you are not in VTOL nor STOL mode. Afterwards when you leave the seat, it will shutdown.



To use WPT AP (Waypoint auto-pilot), you go to the 2nd page on your MFD, which then shows the map. (On the map you can also see other vehicles who have the link 35 datalink, so if 2 YV6s are spawned, you can see eachother. You can also see YV5s.)
When pressing on the map, you will be placing waypoints, which you can place multiple of.
C will clear all the waypoints. N skips the next waypoint, and R removes the last placed waypoint.
Then to Activate AP, you do as written in [H] in seat, the buttons to start AP is by pressing [1]+[3]. If there are no waypoints or it finished the route, WPT AP disables by itself. Remember to activate Keep ALT manually.



Used Microcontrollers:
Plane Altitude Hold
Tajin's Fully configurable GPS Autopilot