订阅以下载
Microscale Eria Colossus (DC/RC)

This is a microscale Eria Colossus heavy bulk carrier. It has the ability to be controlled by a helm or remote controller.

-Detailed exterior, done as close as I could to the real one.
-Night lighting.
-Front spotlights.
-Rotating radars.
-Hatch to the inner areas.
-Equipment included.
-Remote support.
-Deployable lifeboat.

-Extinguishers. x20
-Med kits. x3
-Torches for both above and below water. x8
-Flares. x4
-Included remote controller. x1
-Lots of rope for mooring. x9
-Cables for electrical and fuel. x1
-Radio x1
-Fire gear. x1

Equipment can be found in the two hatches in front of the bridge. Extra rope is scattered around the ship. Electrical and fluid hoses are in the main hatch.

The basic controls are the same for driving it directly or remotely. Check the helm for its control set.

There are two keys needed to start this ship up. The hatch on the rear right has the main engine key, this needs to be activated after the electrical switch beside the helm.

The rear hatch has access to the inner area of the ship.. This can be entered to put out engine fires or check damage.
Fueling can be done on the side of the ship, with two rope connectors. A fluid rope can be found in the main hatch.

Thanks to Frying pan for his simple idle, which helps control this vehicle's engines.

I'm keeping most of my RC boats at the same scale, feel free to visit the collection linked below for more.
https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=2234522928