订阅以下载
Microscale G2 Atlantic Conveyor (DC/RC)

This is a microscale G2 class container ship, based on the Atlantic Conveyor. It has the ability to be controlled by a helm or remote controller.

-Detailed exterior, done as close as I could to the real one.
-Night lighting.
-Front spotlight.
-Rotating radars.
-Hatch to the inner areas.
-Equipment included.
-Remote support.
-Sinking alarm/Sink mode.

-Extinguishers. x4
-Med kits. x2
-Torches for both above and below water. x2
-Flares. x2
-Included remote controller. x1
-Lots of rope for mooring. x11
-Cables for electrical and fuel. x1
-Compass. x1
-Radio x1
-Thermal clothing. x1
-Fire gear. x1

Equipment can be found in the two hatches on the rear deck. Extra rope is scattered around the ship. Electrical and fluid hoses are in the main hatch.

The basic controls are the same for driving it directly or remotely. Check the helm for its control set.

Warning: You may need to press the button twice for something to turn on/off. The controller especially.

There are two keys needed to start this ship up. The hatch under the Helm has the main engine power, after activating that use the key right side of the helm.

To sink, use the key in the hatch under the Helm. This will open two lower areas and allow for sinking. An alarm will sound soon after.

Near the middle of the ship is a hatch. This can be entered to put out engine fires or check damage.
Fueling can be done on the side of the ship, with two rope connectors. A fluid rope can be found in the main hatch.

Here is a bit of info on this ship:
https://www.thinkdefence.co.uk/the-atlantic-conveyor/

Thanks to Frying pan for his simple idle, which helps control this vehicle's engines.

I'm keeping most of my RC boats at the same scale, feel free to visit the collection linked below for more.
https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=2234522928