商店页面

Stormworks: Build and Rescue

全部讨论截图艺术作品实况直播视频创意工坊新闻指南评测

Stormworks: Build and Rescue > 创意工坊 > Uran_Wind 的创意工坊

26 个评价

ZE 8-gear Auto/Manual Transmission

描述讨论0 留言29 改动说明

奖励

Vehicles: Land, Mechanical

Microcontrollers: Microcontroller

标签： v1.11.3

文件大小

发表于

更新日期

25.462 KB

2020 年 8 月 15 日下午 2:15

2024 年 6 月 12 日上午 11:10

7 项改动说明（查看）

3,573	不重复访客数
1,970	当前订阅者
50	当前收藏人数

订阅以下载
ZE 8-gear Auto/Manual Transmission

已订阅

取消订阅

描述

Description

Automatic or manual 8-gear combinative transmission with extra reverse and low gear, requiring 4 gearbox blocks.

Overall gear ratios are:

0.16

0.22

0.31

0.4

0.5

0.68

0.9

1.21
In manual mode gears are shifting sequentially. In automatic mode gear shifting is tuned only by a single engine RPS threshold.
When Manual type is selected, the numeric output node indicates the current gear. When Auto type is selected, transmission is in Drive mode by default and the numeric output node indicates current mode:

2 Low gear

1 Drive

0 Parking

-1 Reverse
In order to limit the top speed you can cut the top gear down to 5-th in microcontroller properties.
The 0-gear is just a placeholder between reverse and 1-gear or Drive mode, so you need a clutch to emulate the Neutral gear in your setup.
You can prevent automatic downshifting with a corresponding node if the engine is under heavy load.

Assembly

Set the gear shifting buttons to the PUSH mode.
Transmission requires 4 gearboxes and torque meter, which should be assembled in the following order:

Engine

Gearbox 1

Gearbox 2

Gearbox 3

Gearbox 4

Torque meter

Optional..

Wheels

▷ Triangles ▷

◁ Triangles ◁

..gearbox..

Ratio Off 3:1

Ratio Off 2:1

Ratio Off 9:5

..to adjust..

Ratio On 1:1

Ratio On 3:2

Ratio On 1:1

Ratio On 1:-1

..the top speed

To adjust the top speed, insert an extra gearbox with any gear ratio between torque meter and wheels.

Assembly reference.

29 条留言

< >

F25 Key 2024 年 8 月 6 日上午 4:37

I tried using this with your digital dashboard and noticed it doesn't go past D1 when using automatic shifting. If I'm not mistaken this is because the gear/auto mode doesn't go past 1 in automatic so I was wondering if you could add an option to output what gear it is in while set to automatic shifting. I would appreciate this addition.