商店页面
Stormworks: Build and Rescue
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Stormworks: Build and Rescue

商店页面
Stormworks: Build and Rescue >  创意工坊 > RJTech 的创意工坊
评价数不足
Ballast controller
描述 讨论0 留言11 改动说明
   
奖励
收藏
已收藏
取消收藏
Vehicles: Air, Sea, Mechanical
Microcontrollers: Fluid, Microcontroller
标签： v0.10.19
文件大小
发表于
41.834 KB
2020 年 6 月 5 日 上午 5:04
1 项改动说明 （ 查看 ）
创建者
RJTech
离线
查看所有 26 个合集（也许有些被隐藏了）
2,247 不重复访客数
787 当前订阅者
12 当前收藏人数

订阅以下载
Ballast controller

描述
This mc is used for ships who's center of mass may be thrown off. It is simple to use and easy to setup.

Instructions:

1. Setup tanks. There should be six tanks (as seen in photo) 3 on each side. Each tank should have an intake and outflow pump.

2. Hook up each pump to the respected slot on the mc

3. Hook up the tilt sensor (one facing forward and one facing right)

4. Activate system :)
11 条留言
< >
ashton902 2023 年 11 月 28 日 下午 11:35 
Currently can not get to work properly set up
ctrain12 2023 年 8 月 20 日 上午 8:11 
it will not register as a saved microcontroller or workshop microcontroller when searched up in the build category
PrimeKing 2022 年 2 月 3 日 下午 3:24 
Hey, there is a problem with the front ballast system. When the mc is not activated the front 2 ballast tanks fill and when you activate them they empty and level out.
GrumpyCamper42 2022 年 1 月 19 日 上午 9:29 
Hi, where are the trim nodes supposed to connect?
fuchs85ch 2021 年 6 月 18 日 下午 2:46 
Question: Would it make sense to modify this in a way that you could either:
- Tell it to keep a certain draft
- Connect a limiter so that it would not fill more than a certain threshold like 50% of the ballast...
We would need to enter all capacities however...
fuchs85ch 2021 年 2 月 24 日 下午 2:37 
Can I use this in my creation for the workshop if I link to your workshop and credit?
Spoggerific 2021 年 1 月 22 日 上午 1:54 
It's looking like this might have a bug where both front IN pumps and the the middle left IN pump are activating while the system is deactivated. Presumably these should be the OUT pumps in order to empty the tank after the system is deactivated.
lucakrowinkel 2021 年 1 月 11 日 下午 1:30 
I used a modified version of this and just wanna come back and say I love it. It's simple yet effective. great work.
ButterKnife 2020 年 10 月 14 日 上午 7:42 
What does Trim mean? Wich Sensor schould be used?
RJTech  [作者] 2020 年 9 月 8 日 下午 3:07 
Yes it still should work without the trim