商店页面
Stormworks: Build and Rescue
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Stormworks: Build and Rescue

商店页面
Stormworks: Build and Rescue >  创意工坊 > Gristle 的创意工坊
评价数不足
Throttle\Winch Control
描述 讨论0 留言5 改动说明
   
奖励
收藏
已收藏
取消收藏
Vehicles: Mechanical
Microcontrollers: Calculation, Modular, Microcontroller
标签： v0.10.24
文件大小
发表于
更新日期
21.214 KB
2019 年 4 月 6 日 上午 6:06
2020 年 6 月 11 日 上午 11:39
5 项改动说明 （ 查看 ）
创建者
Gristle
在线
查看所有 7 个合集（也许有些被隐藏了）
608 不重复访客数
249 当前订阅者
8 当前收藏人数

订阅以下载
Throttle\Winch Control

描述
Use a Throttle control to precisely set the cable length your winch will spool out.

Inputs are:

Throttle setting (number)
Cable Length (number)

Outputs are:

Winch Down (Logic)
Winch Up (Logic)

Occasionally the winch will get into a "bounce" condition. To clear this just adjust the throttle\cable length slightly. I suggest using a low sensitivity on the throttle like %20 - %30.
5 条留言
< >
Garry (no mic) 2024 年 1 月 4 日 上午 1:05 
but it still doesnt work fully
Garry (no mic) 2024 年 1 月 4 日 上午 1:05 
i have fixed it mostly, turns out it was a problem with the crane itself
Gristle  [作者] 2024 年 1 月 2 日 上午 8:06 
Can you post your crane to the workshop? I doubt it's this MC, but will take a look.
Garry (no mic) 2024 年 1 月 2 日 上午 6:04 
And once it gets to full throttle the boom just immediately goes vertical like i said in the comment below.
Garry (no mic) 2024 年 1 月 2 日 上午 5:34 
im using this microcontroller for a crawler crane and connecting the rope nodes to the boom itself, but whenever i put it up over 60% the winch flips out and forces the boom all the way into the vertical position, i dont know if this is a bug or just a problem with my crane but i dont know how to fix it.