商店页面

Stormworks: Build and Rescue

全部讨论截图艺术作品实况直播视频创意工坊新闻指南评测

Stormworks: Build and Rescue > 创意工坊 > Deaders 的创意工坊

评价数不足

HMC - Gyro Output

描述讨论0 留言6 改动说明

奖励

Vehicles: Air

Microcontrollers: Cockpit, Composite, Modular, Microcontroller

标签： v0.5.2

文件大小

发表于

19.067 KB

2018 年 12 月 5 日下午 6:16

1 项改动说明（查看）

759	不重复访客数
153	当前订阅者
2	当前收藏人数

订阅以下载
HMC - Gyro Output

已订阅

取消订阅

描述

This Microcontroller is part of Deaders Helicopter Microcontroller Set.

This particular part is the end of the chain, it unpacks the composite data into output that can connect to the gyro.

If you want to develop other microcontrollers to work with this system, feel free to do so.
The composite protocol I've used is as follows:

Channel 1: Pitch
Channel 2: Roll
Channel 3: Yaw
Channel 4: Collective
Channel 5: Auto Hover

6 条留言

< >

Geley 2019 年 10 月 18 日下午 9:57

I am not sure how Auto-Hover is intended to work. Where does the signal come from, to turn autohover on? I know it is on Channel 5, but how does this auto-hover work in conjunction with the multiple autohover toggles in two-pilot system? Composite is a bit confusing to me, lol

☢️XxDeexX☢ 2019 年 1 月 26 日下午 4:27

@deaders yeah front prop is lower then the rear i could send ya a pic to show how it sits

Deaders [作者] 2019 年 1 月 24 日上午 8:17

@TBSS_LifeStyle I've had similar results in the past, are you using the gyro to autohover? When you do it seems to try to put the two props at the same altitude, if one is below the other then it will likely put that prop higher, also, check your center of gravity, if there is more weight at the front then it will naturally want to lean forwards.

☢️XxDeexX☢ 2019 年 1 月 22 日下午 1:14

sup man i need some help on one of my helis it wount blance its self it has your micr controllers on it and tajins on it butthe choppers dual props and i tranferd it from a steam creation to mine and the front hangs down and will not level off with back prop

Deaders [作者] 2019 年 1 月 6 日上午 9:54

You're more than welcome. I'd like to make some more control modules to add to it. Just having trouble getting any amount of heading hold to work without sending helicopters into a massive spin.

Sir Murtak [108th] 2019 年 1 月 5 日上午 9:09

Just wanna say thanks for these Excellent Micros. I've been using them a lot lately :) They work extremly well.

< >

Stormworks: Build and Rescue

订阅以下载HMC - Gyro Output

编辑链接

订阅以下载
HMC - Gyro Output