订阅以下载
Microwave's Advanced RWR

My RWR system which gives different outputs depending on the type of radar being used, it does as follows:

If a full scan radar (360 degree rotation) is used, you will most like only get a "Ping" warning which shows a Yellow Light on the RGB output and a single output on the "Ping" Buzzer.

If a sweep radar is used it will detect the faster paced inputs (compared to the Ping) and give a "First Stage Radar Warning", which gives a Red Light on the RGB, and a Slow Paced Radar Warning.

If a static radar is used then a "Second Stage Radar Warning" is given, which gives a fast flashing Red light on the RGB, and a Faster Paced Radar Warning.

I have done this to represent mostly help Air Combat as usually a constant radar signal is only present when you are being locked on by a missile or turret, which is usually a bad thing for any plane so it gives the Second Stage warning to basically tell the pilot watch out!

The Radar Warning A and B outputs should be setup to be the same short beep sound, with A being a higher pitch than B, although its not needed it just sounds cooler!

You need 3 Buzzers, an RGB indicator, a Button, and a Radar Detector for this to work, hope you enjoy!