Berlangganan untuk mengunduh
MA Panel Hinge

so the large grid hinge only snaps on backwards. IE, the part that the panel goes on is the only part that will snap to the blocks, and it wont let me put the panel on the other side of the hinge bc its centered for a block

Here is the mod = That rotor is 2 block tall
https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=2781491626

I seen mod with rotor that use the mindset i described.
2 block rotor that base take bottom free block space and rotating part that take upper free block space.

I am searching for 2 block tall hinge that have rotating axis in middle of that 2 blocks.
1 block for base and 1 block for rotating part. As i know Merge block work only IF you have grids aligned as one (with non overlapping blocks). Vanilla hinge use 2 blocks(models) in 1 block space and that is why Merge block not work as hinge will explode.

Merge block works with pistons as you push that slim piston head block far away and in merge action the piston head is in free block space.

Only way i can play SE is with merge block logic as they merge moving parts as single grid and no de-sync happen with moving parts == Less CPU time == Less bugs == Less KlanG

unfortunately i don't have the ability to combine rotor with merge block, and also once the merge happens then any funny stuff (such as these grids being offset by a small amount) will klang out.

Any plan to make 2 block version compatible with merge blocks?
For using merge block hinge base (non moving part) must take only one cube space and moving part also one cube space. 1 cube + 1 cube = 2 cube space. Vanilla hinge not work with merge block as the base + rotating part is in same block space.

thank you

This is one of the first mods I download and make sure isn't broken with patches and DLC. A must-have as far as I'm concerned.

I really wish that this hinge and a 1-block wide variant of it existed in vanilla.

Thank you for reply
Well i am searching for something that can be used with merge block.
Merge block require to have all blocks in grid/line to safely merge/unmerge.

2 block hinge can do this as Static part is block while Moving part is also a block.
Both blocks require own block space = 2 block hinge = 2 block space.
I not care about design of 3D model. It can be just 2 boxes that bend at corner.

no current plans, this one is short and simple