订阅以下载
RNLI - Talus MB-H W/ Mersey Class

This is the variant of the Talus MB-H that comes with the Mersey class lifeboat. For general info about the Talus and the Mersey see their separate links on the workshop. :D

To start up:
- Press "Engine Starter".
- Increase throttle.
- Use W and S to move around.

To deploy the Mersey Class Lifeboat:

- Slowly reverse the trailer into the water (works best on a beach).
- Press "Brakes".
- Press "Magnets Up/Down" and then press "Magnet On/Off" to lock the trailer to the beach.
- Extend the winch so the Mersey slides into the water.
- Press "Connectors On/Off" to detach the Mersey.
- Jump into the Mersey and switch on the engines and drive away .

To recover the Mersey Class Lifeboat:

- Make sure a large portion of the trailer is submerged below the water line like a ramp.
- Very slowly reverse the Mersey so its keel lines up with the trailer.
- If done correctly, the Mersey shall connect onto the trailer and slowly go up.
- Do not turn off the engine at this point, get out, go to the tractor, and turn on the connectors, attach them to the boat.
- Go back to the Mersey, turn off the engines to prevent them overheating out of water.
- Go to the tractor, turn off magnets and retract them. Drive away, happy days.

(It is best done with TWO players, one in the tractor, one in the lifeboat)