conveyors that connect drills together should be replaced with reinforced ones, otherwise 3d printing cant build them, going from back (merge block) to front

The connector block at the rear is not connected to the conveyor grid - can be fixed after removing the merge block and adding a conveyor block instead. I have the problem that when constructing this manually or on a printer, it cannot build one of the programmable blocks - the projection reports that.I cannot see where this would sit - one is next to the antenna, where is the other?

This is one of my favorite blueprints, are you still maintaining them?

turns out my rotor was like half a degree off causing it to not line up...

At the rear, below the connector is a merge block. That is the attachment point if you're using a printer set up like this: https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=1967085548

where do you attach to print off? ive tried soo many locations its getting dumb... also my projector is saying projection out of bounds im confused...

Thanks Helnyx, glad you like!

That is a strange thing to hear about the hydrogen though, since sorters should not affect hydrogen flow, are you sure the base/ship that you are docking it to is making enough hydrogen?

PAM should pull H2 into all tanks on the ship, but you could also try adding the [PAM] tag to them and see if that fixes it?

Love this little ship! I have been using it with PAM. However, It doesnt seem to stockpile Hydrogen when theres a sorter pulling materials out of it.