订阅以下载
Twinbreaker Mobile SAM

Easy Lidar Homing Script used by the Mobile SAM:
http://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=807454034

This Mobile SAM contains 2 missiles with a powerful blast. For the weaker but more missile count version, see Airdart Mobile SAM:
http://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=972523983




1) Hop into cockpit.

2) Press Button #9 to start all computers.

3) Press Button #3 to View Targeting Camera.

4) Aim at target using mouse or controller (Rotors are slaved to mouse input by script).

5) Press Button #1 to Launch Missile.

6) Keep your crosshair aimed at the target until a locked-on sound effect is heard (4 short beeps). There are also flashing red lights beside the crosshair to indicate target locked-on.




1) Use Button #7 to toggle Turret Rotor Safety Lock for moving.

2) Use Button #5 to reduce turret sensitivity and Button #6 to increase sensitivity.

3) Use Toolbar 2 Button #5 to Lower Wheels and Toolbar 2 Button #6 to Heighten Wheels (For Stability).

4) When Wheels are Low enough, use Toolbar 2 Button #7 to Lock Landing Gears to the ground for Maximum Stability. Note: Locking to the ground for the first time may make the Turret unturnable. Don't worry, just Unlock and Lock again if this happens.

5) Use Button #2 to launch missile as Offset Mode. This mode will home to the locked-on point instead of the target's center. This is used to target specific points on a large and slow moving target (e.g. Helicarrier).




1) Reloading requires a separate base setup with overhead welders. Use Toolbar 2 Button #1 to activate Missile Projectors, then drive under an overhead welder station (Not included and not available on my end. Someone else has to build it).