商店页面
Cities: Skylines
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Cities: Skylines

商店页面
Cities: Skylines >  创意工坊 > Employee 432 的创意工坊
评价数不足
The Smoke Grinder Service Interchange
描述 讨论0 留言4 改动说明
   
奖励
收藏
已收藏
取消收藏
Assets: Intersection
文件大小
发表于
521.803 KB
2015 年 5 月 18 日 上午 12:35
1 项改动说明 （ 查看 ）
创建者
Employee 432
离线
查看所有 68 个合集（也许有些被隐藏了）
3,242 不重复访客数
750 当前订阅者
30 当前收藏人数

订阅以下载
The Smoke Grinder Service Interchange

描述
This is a very compact high volume service interchange, with no traffic lights or opposing traffic. It will move a lot of cims while taking up very little space in your city. I created it to solve the problem of cims traveling from one side of a highway to the other interfering with cims trying to get off of or onto the highway. Here, highway access is between the two surface lanes, which avoids having to cross opposing traffic to turn left, and allows through traffic to be diverted around the highway access on the 80kph outside lanes. The lanes for turning right off the highway are underneath the overpass. The highway distance from exit to entrance is only 21 blocks and all highway entrances and exits are at grade and low angle. The highway overpass is set at 9m.

Anyway, I hope you give it a try and tell me what you think.
4 条留言
< >
Ringo 2016 年 4 月 28 日 下午 4:40 
I used this for the first time today - some of the streets underneath seem broken and show the unjoined 1-way error.
Employee 432  [作者] 2015 年 6 月 9 日 下午 12:53 
No, the lanes are kept seperate to reduce conflict points. The weaving is kept to just traffic turning left onto the highway. I don't really like roundabouts.

If you're wondering about u-turns, traffic can perform a u-turn to reverse directions on the highway. To add a u-turn to the surface streets you can wait to bend the surface lanes as they come out from under the interchange, and connect it to the ramp for turning right onto the highway.

As to putting the lanes on top of the highway, I could do one as access for a tunneled highway if you guys want.
shadowwolftjc 2015 年 6 月 6 日 下午 10:56 
@Twilight: It's probably best if the highway is elevated, since it's impossible to zone on strips of highway.

@Employee 432: Is there a roundabout underneath that highway by any chance?
Employee 432  [作者] 2015 年 5 月 18 日 下午 4:45 
@Twilight

Thanks, I'm not sure. I think you would need the no pillars mod which I haven't used. Traffic turning off the highway runs under the highway. The pillar where it intersects with the surface road would be right in the middle of the highway. Maybe, I'll give it a try. For similar capacity, with the surface streets running over the traffic, I would suggest a DCMI (double crossover and merge) interchange.