订阅以下载
100 MW fission reactor

Small two-frame sized closed-loop fission reactor.
Delivers 27MW standalone and 100MW with 3 external turbines attached.
Can operate with low and high enrichment fuel rods.
Controllable with integrated control panel or via data port

setup instructions:
- connect coolant input (located at the side next to power output) to a Water source.
in creative the reactor is already filled with water
- Optional: connect up to 3 turbines to the ports at the back
- insert fuel rods
- flip the ON switch
- flip the Power switch
- you can turn on the screens by pressing the LED in the top-left corner of the dashboard

change fuel rods:
- turn off reactor
- wait for it to cool down. Press SCRAM to turn on the radiator. Keep power output on to
use up more heat.
- when temperature drops below 373 you can access the reactor inventory
- swap fuel rods
- reset scram and turn reactor back on

Ports side:
1x Coolant input (pumps in water to fill the loop)
1x HV power output
1x Data input/output (see Inputs, Outputs)
1x LV emergency power input/output (see LV power)
Ports side bottom:
1x Coolant tank direct access
Ports back:
3x turbine connections: Data | Steam out (red) | Steam return (green) | Power

Radiator:
Turns on during scram or meltdown.
Can be replaced with custom solution. Fluid, Data and power bridges are
located directly behind it.

Inputs:
Ch | Values | Description
0 | 0 / 1 | On/Off
1 | 0 / 1 | Output power
2 | 0 / 1 | SCRAM

Outputs:
Ch | Values | Description
0 | like Fission Reactor | Reactor status
1 | Kelvin | Avg. core temperature
2 | 0 -> 1 | reactor usage (inccurate at <1%)

LV power:
provides LV power even when power output is disabled
can also accept power to jump-start a dead reactor