订阅以下载
Spain Catenary Pack

Please read the manual below before using

Welcome!

This mod gives you the right props to create a Spanish catenary system, including masts, brackets, registration arms and more. Currently, only the CR-160 catenary is included but, as always, the pack will be expanded in the future.
Enjoy!


The Spain Catenary Pack includes modules to create lots of combinations of the CR-160 catenary. Also, an overhead wire, which is compatible with the modules, is included in the pack as a track styke.

To create a simple catenary, please place the following modules in this order:
1. Mast 1
2. Bracket (mono, double or triple), snap to the upper part of the mast.
3. Support 1, snap to the other side of the bracket.
4. Registration arm (1 or 2), snap to the support.
5. Insulator, snap on top of the bracket.
6. Optionally, tensor (1 or 2), snap to the mast.

To create a gantry catenary, which is more complicated, please place these modules:
1. Mast 2
2. Gantry initial, snap to the mast.
3. Gantry middle, snap to the initial module, place as much as you wish.
4. Gantry initial, at the end of the middle chain.
5. Mast 2, after this new gantry initial module.
6. Support 2, snap to a middle module.
7. Bracket (mono, double or triple), snap to the support.
8. Insulator, snap to the bracket.

If you want to create a short catenary:
9. Registration arm (1 or 2), snap to the bracket. It should be next to the support.

If you want to create a long catenary:
9. Support, snap to the empty side of the bracket.
10. Registration arm (1 or 2), snap to the support.

Note: if you have too many problems while building a gantry, which is normal, you can just place the modules manually and then copy the whole catenary.