安装 Steam
登录
|
语言
繁體中文(繁体中文)
日本語(日语)
한국어(韩语)
ไทย(泰语)
български(保加利亚语)
Čeština(捷克语)
Dansk(丹麦语)
Deutsch(德语)
English(英语)
Español-España(西班牙语 - 西班牙)
Español - Latinoamérica(西班牙语 - 拉丁美洲)
Ελληνικά(希腊语)
Français(法语)
Italiano(意大利语)
Bahasa Indonesia(印度尼西亚语)
Magyar(匈牙利语)
Nederlands(荷兰语)
Norsk(挪威语)
Polski(波兰语)
Português(葡萄牙语 - 葡萄牙)
Português-Brasil(葡萄牙语 - 巴西)
Română(罗马尼亚语)
Русский(俄语)
Suomi(芬兰语)
Svenska(瑞典语)
Türkçe(土耳其语)
Tiếng Việt(越南语)
Українська(乌克兰语)
报告翻译问题






在 Twitter 上
在 Youtube 上 


using the new experimental update*
It's a difficult situation. How many pins are standing on the map selection screen? There should be 4 in the vanilla state, and 5 if the MOD has been added.
Also, doesn't it work as well for other maps I'm uploading? Or are there any other mods that are working?
I've done all that and tried all I can, but every time I start a new save, it just loads a generic map.
Please go to the "Map type Wall" page from the summary section and read the comments section.
- Launch the game, check the MOD checkbox, and exit the game once.
- Reload the seed value several times on the map selection screen
If it does not interfere with other MODs, it may be displayed with this.
It depends on the map seed value. We have designed it so that islands do not generate in red areas as much as possible, but they may be generated in those areas depending on the seed value. When starting the game, make sure there are no shallows in the red areas other than the south side.
Although it is mentioned in the summary section, please read the comments section of Map type Wall. That question has been asked before.