订阅以下载
Nanobot Tunnel Bore Drill System

This blueprint uses the Nanobot Drill and Fill System by Dummy08 ( https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=1879455650 ) to quickly allow you to bore out tunnels.

Adjusting Forward, Horizontal, and Vertical offsets

The grid has all blocks prefaced with [XXX] and block groups to allow you to adjust the offsets relatively easily.

The Forward offset can be adjusted by using the [XXX] Drill Systems block group.
The Horizontal offset can be adjusted by using these 5 separate block groups, and applying the appropriate modifier.
[XXX] Drill System (x,-10) eg. if you want 60, use 50
[XXX] Drill System (x,-5) eg. if you want 60, use 55
[XXX] Drill System (x,0) eg. if you want 60, use 60
[XXX] Drill System (x,5) eg. if you want 60, use 65
[XXX] Drill System (x,10) eg. if you want 60, use 70

*Do NOT change the vertical offset when using these block groups.

The Vertical offset can be adjusted by using these 5 separate block groups, and applying the appropriate modifier.
[XXX] Drill System (-10,y) eg. if you want 60, use 50
[XXX] Drill System (-5,y) eg. if you want 60, use 55
[XXX] Drill System (0,y) eg. if you want 60, use 60
[XXX] Drill System (5,y) eg. if you want 60, use 65
[XXX] Drill System (10,y) eg. if you want 60, use 70

*Do NOT change the horizontal offset when using these block groups.

The Width, Height, and Depth can all be adjusted by using the [XXX] Drill Systems block group.

Renaming your blocks/groups to support multiple systems

IF you are intending to use multiple copies of this blueprint on the same grid, you will want to
rename the blocks and groups, and I highly suggest Isy's Block Renaming Script ( https://psteamcommunity.yuanyoumao.com/sharedfiles/filedetails/?id=913293538 ) to do this.

Simply run a replace command as follows:

replace,[XXX],[Your 3 letter code]

You should also rename the block groupings (I've not figured out how to do this automatically)

Otherwise, this blueprint uses vanilla blocks and is safe.