商店页面
Barotrauma 潜渊症
全部 讨论 截图 艺术作品 实况直播 视频 创意工坊 新闻 指南 评测

Barotrauma 潜渊症

商店页面
Barotrauma >  创意工坊 > DuckieMcduck 的创意工坊
评价数不足
null-stream-checker [wip]
描述 讨论0 留言4 改动说明
   
奖励
收藏
已收藏
取消收藏
Item Assembly
文件大小
发表于
290.973 KB
2023 年 5 月 21 日 上午 8:18
1 项改动说明 （ 查看 ）
创建者
DuckieMcduck
在线
查看合集（也许被隐藏了）
51 不重复访客数
0 当前订阅者
0 当前收藏人数

订阅以下载
null-stream-checker [wip]

描述
This is an assembly that should allow you to detect if there's a signal stream coming from a bus sensor, sensors which may output null.

The sensor bus (blue) must be connected to one input of an AND gate. You can have 5 sensors for 1 AND gate.
An oscillator emits a pulse at 60Hz and must be connected to the other input of the AND gate, which basically keeps asking the bus if there's any signal there. I have not noticed any desync issues between using multiple oscillators, but otherwise you can have 1 Oscillator per 5 AND Gates (25 sensors)
An OR gate topology then merges all AND gates. You'll need to add 1 OR gate per additional AND gate.

I have added 12 motion sensors with "1" for true and NULL for false as an example, if any of them triggers and sends a message to the bus then the detector will treat the signal by outputting "1" true. Ceasing movement in all sensors will silence the bus and the checker will handle this by outputting "0" false.

This may all actually be garbage because it mixes timing with signal merging which is mostly undefined behavior in barotrauma, but it may save you some components if it works :)
4 条留言
< >
DuckieMcduck  [作者] 2023 年 8 月 8 日 下午 4:20 
Oh you're right, I didn't notice this behavior but it's also on the wiki :)
Can indeed swap this out with just an OR, or use the OR gate to handle null.
Thanks for speaking out!
DECAFBAD 2023 年 8 月 8 日 上午 5:00 
Not sending a signal or sending 0 is equivalent when you are sending to a LOGIC (!) component: that signal is discarded.
38 signals containing 0, being discarded, and 1 signal that is true will result in:
false OR false OR false OR false OR false ... OR false OR true
The result is: true, the OR component will send its programmed true value.

Only true for logic components, OR, AND, XOR.
DuckieMcduck  [作者] 2023 年 8 月 7 日 下午 5:03 
That won't work, because sending NULL is not considered falsy and will not inform you there's nothing in the bus. You'd merely trigger your system downstream and be unable to shut down.

This showcase shows you how to detect and handle NULL because it's basically always asking if there's something in the bus.
DECAFBAD 2023 年 8 月 7 日 下午 4:35 
All you need is a single OR component, it will output the true value if anything sends 1 to either of the inputs. That means you can have 10 wires from sensors, even more if you connect them with WiFi components.