订阅以下载
The Convertible

MIGHT NEED TO PUT IT ON LIFT A COUPLE TIMES BEFORE IT WORKS PROPERLY



So it took my a couple of hours but I made a working convertible. Doesn't look beautiful, I was only making it to experiment. I wanted to make a small and compact convertible. All of the convertibles I have seen are way too big. I wanted to make a small and compact one. I also didn't want any of the controllers or timers showing. I think I succeeded.
Unfortunately, in an attempt to hide stuff, the main roof piston clips through a wooden panel. This causes the vehicle to freak out sometimes after being taken off the lift. If it freaks out just put it back on the lift and take it off. Normally fixes it.

Hop into the drivers seat.
1 converts the car
2 opens the hood (so you can modify the engine connected to all wheels)
3 opens/closes the left door
4 open/closes the right door
5 opens the back to reveal all the controllers and timers.
6 closes the rear bumper. You can leave it closed afterwards, it is just like that to cut down on block conflicts when it spawns in.

Made for ScrapMan and kAN Gaming.

Have fun!